Справочник Пользователя для Vector VEC37R

DC CHARGER

AC CHARGER

AC and DC recharge requires use of these supplied  

recharge adapters. Do not charge spotlight using  

any other adapters (see figure 5).
 

Make sure that the AC source is 110/120 volts, 60 Hz.
WARNING: Use the supplied AC recharge adapter; do not substitute with any other. AC  

recharge requires the use of the supplied AC recharge adapter that supplies12 volts DC.
DURING AC RECHARGE/OR DC RECHARGE:

a) Never turn on while charging.

b) After recharge – disconnect cord and wait 5 minutes before use.
1. Lift the rubber plug from the recharge port (see Figure 3). It is there to keep out dust and  

  moisture.

2. Connect the wall transformer charger to an AC source.

3. Plug the adapter’s barrel connecter into the recharge port located near the handle.

4. Recharge for 15 hours maximum.

5. After recharge, disconnect the barrel connector from the recharge port and store the adapter.

6. Replace the rubber plug in the recharge port.

Make sure the DC source (jump starter, battery pack, vehicle accessory socket, etc) is 12 volt DC. 

The DC source should be able to supply at least 10 amps at 12 volt DC.
WARNING: Use the supplied DC recharge adapter, do not substitute.
DC recharge requires the use of the supplied DC recharge adapter. Do not substitute with any other.

1. Lift the rubber plug from the recharge port. It is there to keep out dust and moisture.

2. Connect the DC recharge adapter’s DC plug to a 12 volt DC source.

3. Plug the adapter’s barrel connecter into the recharge port located near the handle.

4. Recharge for 3 hours maximum.

5. After recharge, disconnect the barrel connector from the recharge port and store the adapter.

6. Replace the rubber plug in the recharge port.

You may operate the spotlight or area light directly from any 12 volt DC external power source 

supplying at least 10 amp capacity. The internal battery will be recharged while operating the 

spotlight or area light from external DC power source.

All batteries lose charge over time, especially when they are warm. AC recharge is recommended 

every two months, when not in frequent use. Use the AC recharger and charge for the recom-

mended time. If the unit gets dirty gently clean the outer surface of the spotlight unit with a soft 

cloth moistened with a mild solution of water and detergent. Periodically inspect the condition of 

recharge adapters, connectors, and wires. Replace any components that may have become worn 

or broken.

Three parts are replaceable by users. The quartz halogen bulb and sealed lead acid battery are pro-

prietary and are available through Vector Manufacturing. A substitute 12 volt H3 55 watt bulb may be 

used instead of a Vector bulb. These can also be purchased from popular automotive parts suppliers 

nationwide. The DC charging adapter fuse is replaceable. Contact Vector Manufacturing’s Technical 

Support Department for replacement parts and any additional information that you may need. They