Справочник Пользователя для GE ZBD6880K
9
Using the dishwasher
Dishwasher
Water
Temperature
Temperature
The entering water must be at least 120°F
(49°C) and not more than 150°F (66°C), for
effective cleaning and to prevent dish damage.
Check the water temperature with a candy or
meat thermometer. Turn on the hot water faucet
(49°C) and not more than 150°F (66°C), for
effective cleaning and to prevent dish damage.
Check the water temperature with a candy or
meat thermometer. Turn on the hot water faucet
nearest the dishwasher, place the thermometer
in a glass and let the water run continuously into
the glass until the temperature stops rising.
in a glass and let the water run continuously into
the glass until the temperature stops rising.
Use a Rinse
Agent
Agent
A rinse agent improves dry performance,
reduces spots and prevents new film build-up
on your dishes, glasses, flatware, cookware
and plastic. Jet-Dry
reduces spots and prevents new film build-up
on your dishes, glasses, flatware, cookware
and plastic. Jet-Dry
®
and Cascade Rinse Aid
®
are recommended rinse agents for Monogram
Dishwashers.
Dishwashers.
The rinse agent dispenser holds 3.5 oz. of rinse
agent. Under normal conditions, this will last
approximately one month. Try to keep it full,
but do not overfill.
agent. Under normal conditions, this will last
approximately one month. Try to keep it full,
but do not overfill.
To fill the rinse agent dispenser, make sure the
dishwasher is fully open.
dishwasher is fully open.
Turn the dispenser cap to the left and lift it
out. Add rinse agent until the indicator window
shows full.
out. Add rinse agent until the indicator window
shows full.
Clean up any spilled rinse agent with a damp
cloth. Replace the dispenser cap.
cloth. Replace the dispenser cap.
The amount of rinse agent released into the
final wash can be adjusted. The factory setting
is at the midpoint. If there are rings of calcium
(hard water) spots on dishes, try a higher
setting. If there is foaming, use a lower setting.
final wash can be adjusted. The factory setting
is at the midpoint. If there are rings of calcium
(hard water) spots on dishes, try a higher
setting. If there is foaming, use a lower setting.
To adjust the setting, remove the dispenser cap;
then turn the adjuster counterclockwise to
increase the amount of rinse agent.
then turn the adjuster counterclockwise to
increase the amount of rinse agent.
Rinse agent
adjuster
adjuster
Indicator
window
window
Dispenser
cap
cap
Dish
Preparation
Prior to
Loading
Preparation
Prior to
Loading
•
No prerinsing of normal food soil is required.
•
Scrape off hard soils, including bones,
toothpicks, skins and seeds.
toothpicks, skins and seeds.
•
Remove large quantities of any remaining
food.
food.
•
Remove leafy vegetables, meat trimmings and
excessive amounts of grease or oil.
excessive amounts of grease or oil.
•
Remove acidic food soils that can discolor
stainless steel.
stainless steel.
Forget to
Add a
Dish?
Add a
Dish?
A forgotten dish can be added any time before
the main wash.
the main wash.
1.
Open the door slightly.
2.
Wait until the water spray action stops. Steam
may rise out of the dishwasher.
may rise out of the dishwasher.
3.
Add forgotten dishes.
4.
Close the door.