Справочник Пользователя для AEG F89078VI-M
26
Rev 0.0
INSTALLATION INSTRUCTIONS
EN
The plug at the end of the power cord and the corresponding socket must be of
the same type and must conform to current regulations governing electrical ap-
pliances. The plug must be accessible after installation. Never remove the plug
by pulling on the wire. If the power cord is damaged, have it replaced by the
manufacturer or an authorized service centre.
the same type and must conform to current regulations governing electrical ap-
pliances. The plug must be accessible after installation. Never remove the plug
by pulling on the wire. If the power cord is damaged, have it replaced by the
manufacturer or an authorized service centre.
DO NOT USE EXTENSION CORDS, ADAPTORS OR SHUNT CONNECTIONS
IN ORDER TO AVOID THE POSSIBILITY OF OVERHEATING OR BURNING,
WITH CONSEQUENT FIRE HAZARD.
IN ORDER TO AVOID THE POSSIBILITY OF OVERHEATING OR BURNING,
WITH CONSEQUENT FIRE HAZARD.
IN THE EVENT OF DAMAGE TO THE SUPPLY CORD, HAVE IT REPLACED BY
THE MANUFACTURER OR AN AUTHORIZED TECHNICAL SERVICE CENTRE
IN ORDER TO AVOID ANY RISK.
THE MANUFACTURER OR AN AUTHORIZED TECHNICAL SERVICE CENTRE
IN ORDER TO AVOID ANY RISK.
5.3
Commissioning
5.3.1
Installation procedure
(all models)
Clean the underneath of the worktop lying over the dishwasher door (see fi g.
5-15) and apply the steam guard, as shown in fi g. 5-16 (see fi g. 5-16 if the adhe-
sive guard is applied; see fi g. 5-17 if the steel guard is applied). This guard protects
the worktop from steam and condensation when the door of the dishwasher is
opened at the end of the washing cycle.
5-15) and apply the steam guard, as shown in fi g. 5-16 (see fi g. 5-16 if the adhe-
sive guard is applied; see fi g. 5-17 if the steel guard is applied). This guard protects
the worktop from steam and condensation when the door of the dishwasher is
opened at the end of the washing cycle.
Fig. 5-15