Инструкция для Blomberg CTE 30400

Скачать
Страница из 60
ENGLISH
Use & Care Manual
11
Switching off a cooking zone as described below 
disables the Low Power mode. When the zone will be 
selected again it will start to work in the standard power 
mode.
"'  !  
 ^ ^    @;Q &"   „          
heating element.
You may turn off all active elements at the same time by 
 ^^ @;*<;Q&"
(     
   ^    ^^  @;*Q
&"%^~;}€=!    j ^
 ^^@;'!Q&"    < ^
outer ring of a double zone. This operation is possible 
^^~;}€=!  j ^
The dual element enabling indication (ref.5a) is on 
when the element is enabled, is off when the element 
is disabled.
     
 ^    ^^  @;*Q
&"%^~;}€=!    j ^
 ^^@}…?!Q&"    < ^
outer rings of a triple zone:
\ …  "^  %^  
ring is enabled too.
\ …  ^     ^      
enabled, the outer ring is enabled too.
\ …    ^     % ^      ^
intermediate rings are disabled.
These operations are possible until the HOT SURFACE 
  j ^
The intermediate element enabling indication (ref.5a) is 
on when the double element is enabled, is off when the 
double element is disabled.
The outer element enabling indication (ref.5b) is on 
when the triple element is enabled, is off when the triple 
element is disabled.
  !    
Select one of the two single heating areas belonging 
  ^    ^ ^    @;*Q &"% ^ ~;
}€=!    j ^
 ^^@'}…†!Q&"    ^ 
element and set the whole cooking area as a single 
unit. 
This operation is possible until the HOT SURFACE led 
  j ^%     ^  
level:
\ ^   ^# ^ ^
^ @'}…†!Q &"‡  ^ ^  "  ^  ^
same power level and both extension lights (ref.1a, 
1b) turns on.
\  ^ ^ @'}…†!Q &"%  ^ ~; }€=!
        j ^    ^ ˆ  ^
(ref.6a, 6b) turns on. Set the power level that will be 
immediately and simultaneously displayed on both 
displays.
6a
6b
3
3
Figure. 9
; ^    {     % ^ @;*Q  
@;Q &"   ^    #       
used indifferently to control the bridge area. All actions 
will have the same effect on the whole cooking area.
^    {          ^ 
active. It’s always necessary to switch the area off: the 
bridge will be disabled automatically.
)      !
Each element has a HOT SURFACE indicator light 
(ref.3) to show when the cooking area is hot. 
This indication turns on when the zone is activated and 
remains ON until the cooking area has cooled down to 
‰   ^Š    ˆ "„$‹+
If a hot surface light is ON use caution when working 
around the cooktop as it is still hot.
        
Once a heating element has been selected, touch the 
@€';…Q&"  < ^  %  
or after setting the power level. 
A beep sounds and the heater display shows the 
selected power level and a “P” alternatively.