Справочник Пользователя для Indesit KG6408

Скачать
Страница из 12
8
burners, hold a lighted match or lighter near the burner.
Push and turn the corresponding knob counter clockwise
till to max position 
. Each burner can be operated at
its maximum, minimum or intermediate power. Show on
the knob are the different symbols for off • and it is in this
position when the symbol corresponds with the reference
mark for maximum 
 and minimum 
To obtain these
settings, turn the knob counter clockwise with respect to
the off position. To turn off the burner, turn the knob
clockwise until it stops (corresponding again with the
symbol •).
Gas cook-top electronic ignition (4)
This device operates when a sliht pressure is applied on
the botton “4” marked with 
. To light a specific burner
just press the button labeled “4” while pushing the
corresponding knob all the way in and turning it counter-
clockwise until it lights. For immediate lighting, first press
the button and then turn the knob.
Important: should the burner flames accidentally go
out, turn off the control knob and wait at least 1 minu-
te before trying to re-light.
Oven light button (3)
This is marked by the symbol 
 and switchs on the
light inside the oven so that you can control the cooking
without opening the door.
Pilot lamp
This turns on whenever any electric heating element in
the oven is on.
Practical advice for using the burners
In order to obtain the best performance keep in mind the
following:
use the appropriate cookware for each burner (see
table) so that the flames do not emerge from beneath
the bottom of the container.
Only flat bottom containers should be used.
At the boiling point, turn the knob to minimum.
Always use cookware with a lid.
Burner
Cookware Diameter (cm)
Fast Large (RG)
24 - 26
Fast (R)
22 - 24
Semi-Fast (Front right)
16 - 20
Semi-Rapid (Front left)
16 - 20
N.B. On the models supplied with a reducer shelf,
remember that this should be used only for the semi-rapid
burner when you use casserole dishes with a diameter
under 12 cm.
Important: The cooker is equipped with a protective gra-
te located on the front part of the cooking surface to prevent
cookware from falling accidentally. When the front burners
are in use, this grate must be raised.
Inner glass oven door
The cooker is provided with an inner glass that can be
removed unscrewing the two screws. This glass must
be replaced after cleaning and always be in position
when cooking.
Oven door
You can buy a special kit to reduce door temperature when
the oven is on and save energy. If there are little children
in the house, this kit is a must. The kit code number is
039888 or 039104 (for traditional models with plate-metal
door) and it may be purchased for installation from an
authorised dealer or a Technical Assistance Service centre
indicated in the list included with the appliance documents.
12.05
120
7
1
2
3
5
4
The Cooking Programmer
The figure illustrates the controls for the programmer.
Knobs 1, 2 and 3 allow you to make all the necessary
settings.
Knob 1
When turned in the clockwise direction, it allows you to
correct the time setting on the digital clock (upon installa-
tion, after a power failure or when it runs fast or slow etc.).
Knob 2
When turned in the clockwise direction, it:
– sets the duration of the cooking time (max of 210 min-
utes);
– stops the acoustical signal (  setting);
– sets the oven on manual mode (  setting).
The symbols for the above appear in quadrant 4.
Knob 3
When pressed and turned in either the clockwise or coun-
terclockwise direction, it sets the start of the cooking time
displayed in quadrant 5. When the clock is adjusted, you
must check that the time on the clock is synchronized
The cooking programmer