Справочник Пользователя для Bakers Pride FS

 
If a cycle is changed during a timed cook or hold cycle and the time is set for a value that is less than the elapsed 
time for the current cycle, the cycle will be completed when the review mode is exited. 
 
If the cycle in progress goes into audible alert while in review mode, the controller will exit review mode and all 
changes will be canceled. 

Setting a Program 
 

1. Press 

the 

ITEM SELECT button to select the desired program (indicated by the illuminated LED).  

 

2.  Press and hold a function (COOK TEMP, COOK TIME, HOLD TEMP, OR HOLD TIME) button. The 

current setting will be displayed.  
 

3. Press 

the 

UP or DOWN button as needed to display the required setting. 

•  The hold mode may be disabled on any program individually. The timed cook cycle may also be 

disabled, and the controller will operate as a holding timer. This is done by setting the cook or hold 
time to “

OFF”.  

 

•  The controller may also operate with the cook and/or hold temperature set to “OFF”. When both the 

cook and hold temperature are set to “

OFF”, the controller will not regulate the oven temperature. 

This feature is intended for demonstration or display purposes. 

 
Reviewing a Program 
 

1. Press 

the 

REVIEW button. The display will be blank and a program LED will be flashing.  

 

2. Press 

the 

ITEM SELECT button to display the flashing LED for the desired program.  

 

3.  Press and hold the desired function button. The current setting will be displayed.  

 

4.  To change the setting, press the UP or DOWN button while holding the function button. 

 

•  If a button is not pressed within five (5) seconds, the controller will exit review mode and continue the 

cycle previously in progress. 
 

•  The cycle in progress will continue to count up or down accordingly while in the review mode. 

 

•  If a cycle is changed during a timed cook and/or hold cycle and the time is set for a value that is less 

than the elapsed time for the current cycle, the current cycle will be completed when the review mode 
is exited.  
 

•  If the cycle in progress goes into audible alert while in review mode, the controller will exit review 

mode and all changes will be canceled. 

1. Place 

the 

POWER switch, OVEN LIGHTS switch, and ROTOR CONTROL switch located on the front 

panel in the “ON” position. The controller will automatically load the settings from the last program 
selected and begin regulating to the cook or hold temperature. Typically, the oven temperature is too cool 
upon power-up. If the oven temperature is below the programmed temperature, the display will alternately 
flash “

too”, “CooL” until the oven temperature reaches the programmed temperature.