Справочник Пользователя для Bunn MCPA

7

•  WATER RESERVOIR - Holds reserve water for brewing. The reservoir can be 

removed and filled separately at a sink or other clean water source or by pouring 

water through the slide lid. (Holds 1.7 L (46 oz.) to the maximum line.)

•  SLIDE LID - The slide lid allows access to the reservoir. Water can be poured 

through the opened lid and into the reservoir without removing the reservoir.

•  POD HOLDER RELEASE BUTTON - Push to unlock and release the pod holder. 

When there is power to the brewer, this button will illuminate red in color, showing 

the trademark BUNN name. This light will go out during a brew cycle and when 

the brewer has gone into Sleep Mode. (Refer to the  “Features” section on page 8 for 

more information.)

•  BLUE (BREW) LIGHTS - Blue colored lights are located near the pod holder  area 

and light up to indicate that a brew cycle is in process.

•  SPRAYHEAD SEAL - The seal keeps water under pressure from escaping, while 

a brew cycle is in process. If leaks are present during a brew cycle, consult the 

“Troubleshooting” section on page 15.

•  SPRAYHEAD - Designed to distribute water evenly across the coffee pod or tea 

bag/pod to extract the proper flavor.

•  POD HOLDER INSERT - A color-coded, removable screen designed to allow 

proper flow rates and steeping capabilities for the type of brew desired.

•  POD HOLDER - Holds the coffee pod or tea bag/pod.

•  DRIP TRAY GRATE - A removable part that allows any spilled liquid to drip 

through into the drip tray.

•  DRIP TRAY- Removable tray that is designed to catch any spilled liquid.

•  POWER SWITCH- Turns on and off all electrical service to the brewer. This button 

is only to be used when the brewer will not be used for several days. (In the “I” 

position the power is on. In the “O” position the power is off.)

•  VOLUME CONTROL SLIDE LEVER - Adjusts the amount of water dispensed 

through the pod holder. Sliding it left will produce a smaller serving. Sliding it to 

the right will produce a larger serving. The brewer will dispense approximately 

118 to 355 ml (4 to 12 oz.) in 30 ml (1 oz.) increments.

•  CONTROL PANEL - Controls for brewing coffee or tea and various indicators are 

located on the control panel. (FIG. 2)  See specific definitions below.

•  COFFEE BREW BUTTON - Depress this button to brew a serving of coffee. Pressing 

•  REFILL WATER INDICATOR - If the water in the reservoir is running low, and either 

the Coffee or Tea  Brew button is pressed, this indicator will flash for a few seconds 

to show that the water reservoir needs to be refilled. A brew cycle cannot be started 

until the reservoir has been refilled.