Справочник Пользователя для Vulcan-Hart EF4 ML-114943

– 11 –

5. Allow temperature to stabilize at new setting

and compare temperature tester to dial setting.
Recalibrate if the temperature does not fall
within the range of 330°F to 370°F.

6. If the temperature does not fall within the

limits at both settings, replace the thermostat.

1. Light pilot as outlined under Lighting Pilot on

page 3.

2. If the flame does not extend beyond the outer

edges of the pilot shield 

1

/

2

", or extends more

than 

1

/

2

", an adjustment is necessary.

3. Remove the cap covering pilot adjustment

screw. Turn the recessed pilot adjustment
screw counterclockwise to increase the size
of the flame or clockwise to decrease the
size of the flame.

PL-56158

WARNING:  SHUT OFF THE GAS BEFORE
SERVICING.

If the burner ports become clogged, the fryer will not
operate properly. If the burner is cracked, it must be
replaced.

1. Remove burner(s) as outlined under Burners.

2. Check burner(s) for cracks and clogged ports.

3. If the ports are clogged, wash burner(s) in

warm, soapy water. If this does not remove
obstructions, a #37 drill bit can be used (do
not use in an electric drill; hand-turn only).

1. Remove the burners as outlined under

Burners.

2. Hold the burner nozzle with channel locks

and remove the orifice. Check the orifice for
obstructions or damage.

3. If the orifice is clogged, wash the orifice in

warm, soapy water. If this does not remove
obstructions, a #37 drill bit can be used (do
not use in an electric drill; hand-turn only).

4. With channel locks, remove the burner nozzle.

5. Reverse procedure to install new burner

nozzle and orifice.