Справочник Пользователя для Fisher & Paykel OD302
6
Warnings & safety information
WARNING
Cut Hazard
Take care - panel
edges are sharp.
edges are sharp.
Failure to use caution
could result in minor
injury or cuts.
could result in minor
injury or cuts.
CAUTION!
In order to avoid hazard these products
must be installed according to these
instructions.
instructions.
IMPORTANT!
Please make this information available
to the person responsible for installing
the product as it could reduce your
installation costs.
the product as it could reduce your
installation costs.
Correct installation is the responsibility
of the customer. Ensure that the installer
is properly qualified to install this oven.
is properly qualified to install this oven.
Read these instructions carefully before
installing or using this product.
Before you start
Make sure that the oven is located away
from any strong and/or hot drafts of air.
The cabinet opening dimensions specified
are the absolute minimum. These
dimensions allow a clearance of up to 1/4”
(6mm).
dimensions allow a clearance of up to 1/4”
(6mm).
The product must be electrically grounded.
See “Electrical Connection” for details.
We recommend that the electrical supply
junction box is located either 3’’ below the
main support surface of the product on
the right hand side or flush mounted in the
rear wall behind the product or mounted in
the adjacent right-hand side cabinet. A 1”
diameter hole should be drilled in the right
rear corner of the oven cabinet or in the
rear of the right-hand side wall as required
to enable the electrical supply cord to be
passed through the cabinet to the junction
box. Details of these requirements are
shown in the diagram to the right.
main support surface of the product on
the right hand side or flush mounted in the
rear wall behind the product or mounted in
the adjacent right-hand side cabinet. A 1”
diameter hole should be drilled in the right
rear corner of the oven cabinet or in the
rear of the right-hand side wall as required
to enable the electrical supply cord to be
passed through the cabinet to the junction
box. Details of these requirements are
shown in the diagram to the right.
The oven support surface should be flat,
level and be able to support a weight of at
least 420 pounds (190 Kg) for a double oven
and 238 pounds (108 Kg) for single oven
models.
least 420 pounds (190 Kg) for a double oven
and 238 pounds (108 Kg) for single oven
models.
You will need a No.2 Phillips screwdriver to
complete the installation of the oven into
the cabinet. There should be 4 suitable
wood screws with this installation kit (Part
number 556075) and 4 spacers (Part number
545455).
the cabinet. There should be 4 suitable
wood screws with this installation kit (Part
number 556075) and 4 spacers (Part number
545455).
A Fisher & Paykel CE901 cooktop can be
installed above an OS301 single wall oven
if a 3/8” (10mm) gap is provided between
the top of the oven and the bottom of the
cooktop.
if a 3/8” (10mm) gap is provided between
the top of the oven and the bottom of the
cooktop.
WARNING
Very Heavy
Do not attempt to
lift this product
unassisted.
lift this product
unassisted.
Lifting unassisted
may cause serious
injury.
may cause serious
injury.
420 lb
190 kg
238 lb
108 kg
OS302
OD302