Справочник Пользователя для Insys GSM 4.2 I4 11-02-01-03-01.038
Модели
11-02-01-03-01.038
INSYS GSM 4.2 I4
Functions and their configuration
Dez-06
53
If during the alarm processing of one input the other input is activate, the device stores
the second alarm state. The device will first complete the processing of the first alarm
before processing the second alarm (in chronological order).
If no connection can be established, the device attempts as many dial-ups as configured
in the basic settings, in intervals of approximately 60 seconds (see Chap. 6.1.3).
The LED Status is flashing during the alarm processing.
the second alarm state. The device will first complete the processing of the first alarm
before processing the second alarm (in chronological order).
If no connection can be established, the device attempts as many dial-ups as configured
in the basic settings, in intervals of approximately 60 seconds (see Chap. 6.1.3).
The LED Status is flashing during the alarm processing.
6.3.6 Main recipient and additional recipients
You must assign each alarm message a main recipient.
Each alarm message, which is dispatched by SMS or via "Short data connection", can be
sent additionally to 10 further recipients from a pool of 20 numbers.
The alarm messages are all transmitted in the same way (via SMS or "Short data connec-
tion") to the main recipient and the additional recipients.
Each alarm message, which is dispatched by SMS or via "Short data connection", can be
sent additionally to 10 further recipients from a pool of 20 numbers.
The alarm messages are all transmitted in the same way (via SMS or "Short data connec-
tion") to the main recipient and the additional recipients.
6.3.7 Configure alarms
You can configure the alarms with the configuration software HSComm or directly with
AT commands.
AT commands.
Restrictions for SMS texts
The internal GSM character set does not match the usual ASCII
character set of PCs in all positions.
Therefore, the following restrictions must be observed for SMS
texts:
The internal GSM character set does not match the usual ASCII
character set of PCs in all positions.
Therefore, the following restrictions must be observed for SMS
texts:
Never use the character 0x00h.
Permitted text characters in SMS messages are only letters
Permitted text characters in SMS messages are only letters
(without umlauts), digits, punctuation marks, brackets, un-
derscore, %, & *.
derscore, %, & *.
8-bit characters (e.g. umlauts) and $ @ { } [ ] ^ ° ` ´ are not
supported.
In e-mail addresses, the character @ must be replaced by the
character * . KPN in the Netherlands requires replacement by
the character!
the character!
If you do not enter the message text via the entry mask of
the HSComm software, you must replace the underscore by
the letter 0x11h.
the letter 0x11h.