Справочник Пользователя для Hoshizaki C-100BAF-ADDS

32

1) Move the power switch to the "OFF" position, then unplug the unit from the electrical 

outlet. 

2) Close the water supply line shut-off valve.
3) Remove all ice from the storage bin.
4) While maintaining a hold on the door, remove the hinge stop pin from hinge (B). Pull out 

the bottom of the door slightly, then gently remove the door from hinge (A). See Fig. 7.

5) Remove the top panel.
6) Remove the spout.
7) Remove the upper rear panel. See 

Fig. 9.

8) Remove the clamp securing the drain 

plug, then lower the drain hose into a 
container. Remove the drain plug to 
drain the water from the reservoir and 
evaporator assembly. 

9) After all of the water has drained, 

replace the drain hose, drain plug, 
and drain clamp in their original 
positions.

10) Remove the cutter and packing.
11) Remove the allen head cap screws 

securing the extruding head and 
evaporator flange, then lift off. 

12) Place the evaporator flange and new extruding head in place, then tighten down the 

allen head cap screws. 

13) Open the water supply line shut-off valve and check for water leaks. Replace the 

removed parts in the reverse order of which they were removed.

14) Plug the unit back in. Move the power switch to the "ON" position.

1) Move the power switch to the "OFF" position, then unplug the unit from the electrical 

outlet. 

2) Close the water supply line shut-off valve.
3) Remove all ice from the storage bin.
4) While maintaining a hold on the door, remove the hinge stop pin from hinge (B). Pull out 

the bottom of the door slightly, then gently remove the door from hinge (A). See Fig. 7.

5) Remove the top panel.
6) Remove the spout.
7) Remove the upper rear panel. See Fig. 9.

Spout

Extruding 

Head

Packing

Upper Rear Panel

Clamp

Drain Plug

Drain Hose

Cutter

Evaporator 

Flange

Reservoir Hose

Evaporator 

Condensate Drain Pan