Справочник Пользователя для Hoshizaki C-100BAF-ADDS
42
B. Maintenance
The maintenance schedule below is a guideline. More frequent maintenance may be
required depending on water quality, the icemaker's environment, and local sanitation
regulations.
required depending on water quality, the icemaker's environment, and local sanitation
regulations.
WARNING
1. Only qualified service technicians should attempt to service this icemaker.
2. Move the power switch to the "OFF" position and unplug the unit from the
2. Move the power switch to the "OFF" position and unplug the unit from the
electrical outlet before servicing.
Maintenance Schedule
Frequency Area
Task
Weekly
Scoop
Clean the scoop using a neutral cleaner. Rinse thoroughly after cleaning.
Monthly
External Water
Filters
Filters
Check for proper pressure and change if necessary.
Icemaker Exterior
Wipe down with clean, soft cloth. Use a damp cloth containing a neutral
cleaner to wipe off oil or dirt build up. Clean any chlorine staining (rust
colored spots) using a non-abrasive cleaner like Zud or Bon Ami.
cleaner to wipe off oil or dirt build up. Clean any chlorine staining (rust
colored spots) using a non-abrasive cleaner like Zud or Bon Ami.
Every 6
Months
Months
Icemaker and
Storage Bin
Storage Bin
Clean and sanitize per the cleaning and sanitizing instructions provided in
this manual. See "III. A. Cleaning and Sanitizing Instructions."
this manual. See "III. A. Cleaning and Sanitizing Instructions."
Evaporator
Condensate Drain
Pan and Gear
Motor Drain Pan
Condensate Drain
Pan and Gear
Motor Drain Pan
Wipe down with clean cloth
and warm water.
and warm water.
Storage Bin Drain
Maintain as outlined in "III.B.1. Storage Bin Drain."
Yearly
Water Supply Inlet Close the icemaker water supply line shut-off valve and drain the water
system. Clean the water supply inlet screen.
Condenser
Inspect. Clean if necessary. See "III.B.2. Condenser."
Water Hoses
Inspect the water hoses and clean/replace if necessary.
Upper Bearing
(extruding head)
(extruding head)
Check for wear using .02" round stock or pin gauge. Replace both upper
bearing and lower bearing if wear exceeds factory recommendations. See
the Service Manual for details.
bearing and lower bearing if wear exceeds factory recommendations. See
the Service Manual for details.
After
3 Years,
then Yearly
3 Years,
then Yearly
Upper Bearing
(extruding head);
Lower Bearing
and O-Ring
(lower housing);
Mechanical
Seal; Evaporator
Cylinder; Auger
(extruding head);
Lower Bearing
and O-Ring
(lower housing);
Mechanical
Seal; Evaporator
Cylinder; Auger
Inspect. Replace both upper bearing and lower bearing if wear exceeds
factory recommendations. Replace the mechanical seal if the seal's contact
surfaces are worn, cracked, or scratched.
factory recommendations. Replace the mechanical seal if the seal's contact
surfaces are worn, cracked, or scratched.
Gear Motor
Drain Pan
Evaporator
Condensate
Drain Pan