Справочник Пользователя для Electrolux 231 GR

10

Caution: In order to avoid a hazard this 
appliance must be installed according to 
these instructions for installation

The appliance unit can be mounted  in 
any type of kitchen with a work top 
whose thickness is between 28 mm and 
40 mm.

The distance between the top side of the 
work top and the carpentry underneath 
must be at least 47 mm.

Screw the fixing brackets out to such an 
extent that they can be turned in under 
the work top. Tighten the brackets on to 
the work top with an ordinary 
screwdriver.

One rectangular hole is sawn out for the 
appliance combination chosen.
The depth of the cut-out for any unit is: 
490 mm
Length of hole = sum of all units` 
externally measured length, less 20 mm.

A reinforcement Beam, with supporting 
flanges at each end, is included with 
each two-burner unit. For unit 
combinations, a reinforcement beam 
must be used between each unit. 

Min. 47 mm

Minimum distance

to side wall:

150 mm

Minimum distance

to rear wall (non-

flammable material):

150 mm

Reinforcement

beams

11

It is not necessary to attach the 
reinforcement beam to the work top 
surface, as it is held in place by a 
specially designed moulding, which is 
incorporated in the hob units flanges. 

145 mm:
Cooker hood

290 mm:
Two-zone ceramic-top electric hob
Two-burner gas hob
Grill 
Fryer
Wok

580 mm: 
Four-zone ceramic-top electric hob
Four-burner gas hob 

725 mm:
Four-zone ceramic-top electric hob

When mounting a single unit, be it a 
half-or full size unit, in a 
worktopsurface which is thicker than 
30 mm, it is necessary to make a 
special notch in both sides of the cut-
out hole, as shown in the adjacent 
drawing.
The purpose of these notches is to 
create space for the electrical cables.