Справочник Пользователя для HP (Hewlett-Packard) 4100N

156 Chapter  4 - Problem solving

EN

Use the font lists to see which fonts are currently installed in the 
printer. (The font lists also show which fonts are resident on an 
optional hard disk accessory or flash DIMM.)

At the printer control panel, press 

M

ENU

 until 

INFORMATION MENU

 

appears.

Press 

I

TEM

 until 

PRINT PCL FONT LIST

 or 

PRINT PS FONT LIST

 

appears.

Press 

S

ELECT

 to print the font list.

The PS font list shows the PS fonts installed, and gives a sample of 
those fonts. The following describes the information that can be found 
on the PCL font list:

●

Font gives the font names and samples.

●

Pitch/Point indicates the pitch and point size of the font. 

●

Escape Sequence (a PCL 5e programming command) is used to 
select the designated font. (See the legend at the bottom of the 
font list page.)

For step-by-step instructions on using printer commands to select a 
font with DOS applications, see “Selecting PCL 5e fonts” on page 238.

●

Font # is the number used to select fonts from the printer control 
panel (not the software application). Do not confuse the font # 
with the font ID, described below. The number indicates the DIMM 
slot where the font is stored.

• SOFT: Downloaded fonts, which stay resident in the printer 

until other fonts are downloaded to replace them, or until the 
printer is turned off.

• INTERNAL: Fonts that permanently reside in the printer.

●

Font ID is the number you assign to soft fonts when you 
download them through software.