Листовка для RCA 42-7011
© 2003 RadioShack Corporation. All Rights Reserved.
42-7011
Dual-Tray CD Player/Recorder
Refer to your Owner’s Manual for complete instructions.
RadioShack Corporation
Fort Worth, Texas 76102
Fort Worth, Texas 76102
03A03
Printed in China
S-VIDEO IN
S-VIDEO OUT
CONNECTING AND POWERING YOUR RECORDER
Follow the diagram to connect your recorder to your receiver.
I
NSTALLING
BATTERIES
1. Press down on the battery compartment cover and slide it
off in the direction of the arrow.
2. Insert the batteries into the battery compartment as
indicated by the polarity symbols (
+
and
–
) marked inside.
3. Replace the cover.
A QUICK LOOK AT THE REMOTE
PLAYING A CD
You can use the RECORD/PLAYBACK tray to play back CD, CD-R, and CD-
RW discs. You can use the PLAYBACK tray to play back CD and finalized
CD-R/CD-RW discs. You cannot play CD-R/CD-RW discs that have not
been finalized on the PLAYBACK tray.
RW discs. You can use the PLAYBACK tray to play back CD and finalized
CD-R/CD-RW discs. You cannot play CD-R/CD-RW discs that have not
been finalized on the PLAYBACK tray.
1. Press
POWER
on the recorder.
READING
flashes for a while. When no
disc is set,
no DISC
or
DISC no
appears.
2. Press the respective
OPEN/CLOSE
for the PLAYBACK tray or the
RECORD/PLAYBACK tray.
3. Carefully place the disc, label side up, into the recessed CD holder.
4. Press
OPEN/CLOSE
for the PLAYBACK tray or the RECORD/
PLAYBACK tray to close the disc tray. When a disc is loaded into the
recorder,
recorder,
READING
flashes as it determines the contents of the disc.
When the recorder reads the TOC (Table of Contents), the display shows
the total number of tracks, total play time, and the type of disc (the
RECORD/PLAYBACK tray only).
the total number of tracks, total play time, and the type of disc (the
RECORD/PLAYBACK tray only).
• When a blank disc is set on the RECORD/PLAYBACK tray,
BLANK
appears.
• When a disc is set on the RECORD/PLAYBACK tray, the display shows
one of the following:
CD
— a commercial pre-recorded CD.
CD-R
— finalized CD-R.
CD-R,
NO TOC — a CD-R which has yet to be finalized.
CD-RW,
NO TOC — a CD-RW which has yet to be finalized.
CD-RW
— a finalized CD-RW.
BLANK
— No disc or unreadable disc.
5. Press ² for the PLAYBACK tray or
²
/
ENTER
for the RECORD/PLAYBACK tray to start playback.
6. Press † to temporarily stop playback. To resume playback, press † or ².
7. Press
G to stop playback.
If you set CDs on both the PLAYBACK tray and the RECORD/PLAYBACK
tray, the recorder automatically plays the other CD when the current CD
finishes. The CD recorder stops playing at the end of the second CD.
tray, the recorder automatically plays the other CD when the current CD
finishes. The CD recorder stops playing at the end of the second CD.
A QUICK LOOK AT THE RECORDER
“Think RadioShack for all of Your
CD Player/Recorder Accessories”
Headphones
Batteries
Blank CD-R Discs
Optical Cable
Audio Cable
CD Lens Cleaner
POWER
REMOTE
SENSOR
SENSOR
PHONES
STOP
DUBBING
MODE
MODE
AUTO
MANUAL
MANUAL
OPEN/
CLOSE
CLOSE
INPUT
SELECTOR
SELECTOR
MUSIC SKIP Buttons
FINALIZE
ERASE
SYNC REC RECORD
MUSIC SKIP
Buttons
Buttons
OPEN/
CLOSE
CLOSE
DIGITAL REC
LEVEL –/+
LEVEL –/+
PLAY
PAUSE
STOP
PLAY
PAUSE
Note: The receiver, shown above, does not have digital out jacks. If your
receiver also does not have digital out jacks, you can use a digital source such as
a CD player or MD player.
receiver also does not have digital out jacks, you can use a digital source such as
a CD player or MD player.