Справочник Пользователя для Fujitsu MBA3147NC
A.1
Setting Terminals (on NP model only)
Table A.1
CN2 setting terminal (on NP model drives only)
Pin pair
Setting item
1 - 2
3 - 4
5 - 6
7 - 8
9 - 10
Setting contents
Open Open Open (Open)
SCSI ID #0 (Common to 8-bit and 16-bit SCSI)
Short Open Open (Open)
SCSI ID #1 (Common to 8-bit and 16-bit SCSI)
Open Short Open (Open)
SCSI ID #2 (Common to 8-bit and 16-bit SCSI)
Short Short Open (Open)
SCSI ID #3 (Common to 8-bit and 16-bit SCSI)
Open Open Short (Open)
SCSI ID #4 (Common to 8-bit and 16-bit SCSI)
Short Open Short (Open)
SCSI ID #5 (Common to 8-bit and 16-bit SCSI)
Open Short Short (Open)
SCSI ID #6 (Common to 8-bit and 16-bit SCSI)
Short Short Short (Open)
SCSI ID #7 (Common to 8-bit and 16-bit SCSI)
Open Open Open Short
SCSI ID #8 (16-bit SCSI only)
Short Open Open Short
SCSI ID #9 (16-bit SCSI only)
Open Short Open Short
SCSI ID #10 (16-bit SCSI only)
Short Short Open Short
SCSI ID #11 (16-bit SCSI only)
Open Open Short Short
SCSI ID #12 (16-bit SCSI only)
Short Open Short Short
SCSI ID #13 (16-bit SCSI only)
Open Short Short Short
SCSI ID #14 (16-bit SCSI only)
SCSI ID
Short Short Short Short
SCSI ID #15 (16-bit SCSI only) (*)
Open Write operation is enabled. (*)
Write protect
Short
Write
operation
is
disabled.
Pin pair
Setting item
11 - 12 13 - 14 15 - 16 23 - 24
Setting contents
Motor start mode
Open
Started by the START/STOP command
Short
Started by turning the power supply on (*)
Force Narrow
Open
Width of 16-bit bus (*)
Short
Width of 8-bit bus
Force Single Ended
Open
Follows DIFFSNS signal level on SCSI bus (*)
Short
Single-Ended
mode
Terminating power supply
Open
Does not supply terminating resistor power to SCSI BUS
Short
Supply terminating resistor power to SCSI BUS (*)
* Setting at factory shipment
Note:
See the description of Section 5.3 for details of the setting requirements and notes.
118
C141-E270