Справочник Пользователя для Shindaiwa X7501970601

Скачать
Страница из 28
10
Storage - Fuel storage laws vary by 
locality. Contact your local govern-
ment for the laws affecting your area. 
As a precaution, store fuel in an ap-
proved, airtight container. Store in a 
well-ventilated, unoccupied building, 
away from sparks and flames. 
IMPORTANT! 
Stored fuel may separate. ALWAYS 
shake fuel container thoroughly 
before each use.
Mixing Instructions 
 
1.  Fill an approved fuel container with half of the required amount of gasoline.
  2.  Add the proper amount of engine oil to gasoline.
  3.  Close container and shake to mix oil with gasoline.
  4.  Add remaining gasoline,  close fuel container, and remix.
IMPORTANT! 
Spilled fuel is a leading cause of hydrocarbon emissions. Some states may 
require the use of automatic fuel shut-off containers to reduce fuel spillage.
After use
•  DO NOT store a unit with fuel in its tank. Leaks can occur. Return unused fuel 
to an approved fuel storage container.
Remove
the
Fuel
Filler
Cap
Filling the Fuel Tank
Place the unit on a flat, level surface.
1. 
Clear any dirt or other debris from around the fuel filler cap.
2. 
Remove the fuel cap, and fill the tank with clean, fresh fuel.
3. 
Reinstall the fuel filler cap and tighten firmly.
4. 
Wipe away any spilled fuel before starting the blower.
5. 
Starting the Engine
 
Danger from rotating impeller! The impeller will rotate whenever the 
blower is operated! Never operate this blower unless the intake cover and 
blower tubes are properly installed and in good working order!
CAUTION!
The recoil starter can be damaged by abuse!
• Never pull the starter cord to its full length!
• Always engage the starter before cranking the engine!
• Always rewind the starter cord slowly!
• Never operate the blower if blower tubes are missing or damaged! 
WARNING!
            
WARNING! 
            
Danger from thrown dust or debris! Always wear eye protection 
when operating this machine! Never direct the blower stream toward people or 
animals!  Never operate this blower unless all controls are properly installed and 
in good working order.