Справочник Пользователя для 3D Connexion LST42B

8

STEP 4:  (SEE FIGURE 4)
•

Assemble a shoulder bolt (L) and a 3/8" washer (T) to 
the outside of R.H. side plate, securing it with a 3/8" 
fl anged nut (X). Repeat for L.H. side plate.

STEP 3:  (SEE FIGURE 3)
•  Fasten the R.H. Side Plate (bend facing out) to the 

front three holes in the tractor frame using three 3/8" 
x 1" carriage bolts (G), three 1/2" washers (R) (see 
note) and three 3/8" fl ange nuts (X). For the rear hole, 
use a 5/16" x 1" carriage bolt (J), a 1/2" washer (R) 
and a 5/16" nylock nut (Y). Place the 1/2" washers (R) 
between the tractor frame and the side plate. Repeat 
for L.H. side plate.

•  Reinstall the browning shield onto the tractor frame 

using the original screws.

NOTE: If there is an engine mounting plate (shown with 
dotted lines) leave the 1/2 washer off the bolt that goes 
through the plate.

STEP 5:  (SEE FIGURE 5)
•

Remove the bolt, if present, in the hole directly behind 
the brake rod on the left side of the tractor frame.

•  Attach the L.H. Hanger Bracket (tube facing out) to the 

hole using a 5/16" x 3/4" self threading bolt (F).

•  Install a round head shoulder bolt (M) into the hole 

that is 9-1/2" to the rear of the bolt you just installed. 
Secure it with a 3/8" fl ange nut (X) on the inside of the 
frame.

STEP 6:  (SEE FIGURE 6)
•

Remove the bracket, if present, from the hole directly 
behind the end of the brake rod on the right side of 
the tractor frame. Store the bracket and bolt.

•  Attach the R.H. Hanger Bracket to the hole using a 

5/16" x  3/4" self threading bolt (F).

•  Install a round head shoulder bolt (M) into the hole 

that is 9-1/2" to the rear of the bolt you just installed. 
Secure it with a 3/8" fl ange nut (X) on the inside of the 
frame.