Справочник Пользователя для Samson VHF Series

Guided Tour - VR3 Rear Panel

1:  DC input - Connect the supplied 12 volt 250 mA power adapter here, using the strain
relief as shown in the illustration below.  WARNING: The substitution of any other kind of
power adapter can cause severe damage to the VR3 and will void your warranty.

2:  Unbalanced output* - Use this unbalanced high impedance (5K Ohm) 1/4" jack when
connecting the VR3 to consumer (-10) audio equipment.  Wiring is as follows: tip hot,
sleeve ground.

3:  Audio Output Level switch - Sets the audio output level attenuation of the balanced
output (see #4 below) to -20 dBm  (line level) or -40 dBm (mic level).  See the“Setting Up
and Using Your VHF TD Series / VHF Series System” section on page 10 in this manual
for more information.

4:  Balanced output* - Use this electronically balanced low impedance (600 Ohm) XLR
jack when connecting the VR3 to professional (+4) audio equipment.  Pin wiring is as
follows: Pin 1 ground (shield), Pin 2 high (hot), and Pin 3 low (cold).

8

ENGLISH

+

-

DC INPUT

UNBALANCED OUTPUT

CAUTION

USE SAMSON

AC ADAPTER

ONLY

A

C

 CABLE LOCK

CABLE LOCK LOOP THRU AND TIE

-10 dB 5K

Ω

S. No.   

CH :   

Non-Diversity Receiver

F: 

BALANCED SWITCH 

LINE:
-20dBm600

Ω

MIC:
-40dBm600

Ω

MIC

LINE

BALANCED OUTPUT

XLR:

①

GND

②

HOT

③

COLD

POWER RATING

DC 12V, 1.9W(160mA)

1

2

3

4

-