Справочник Пользователя для Liebherr RO 500
10
o
peraTion
Setting the Temperature
-
Figure 7
To reduce the temperature: Press the Down but-
ton.
To increase the temperature: Press the Up button.
- While you are entering the temperature, the set
temperature will flash on the display.
- You can change the settings in increments of
1°F (1°C) by briefly pressing the button again.
The electronic controls will switch over automati-
cally about five seconds after the last time you
pressed the button. The actual temperature will
display.
Figure 7
If
F0, F1
or
F7
appears in the display, the appliance
has a fault. Contact your nearest customer service
representative.
Ventilation button
-
Figure 8
The ventilation button can be used to increase the
relative humidity in the interior.
•
To switch on: Press the Ventilation button. The
indicator lamp in the button will light. The fan is
permanently in operation = higher humidity.
•
To switch off: Press the button again so that the
fan symbol goes dark. The fan runs in parallel to
the compressor = lower humidity.
Note:
- The energy consumption will increase when the
fan is switched on.
- To save energy, the fan will switch off automati-
cally when the door is open.
Figure 8
Operating and
Control Elements
-
Figure 5
Figure 5
1
Temperature display
2
Temperature setting buttons
3
Alarm On/Off button
4
Fan switch
5
Childproof lock
6
On/Off button
Turning the Appliance
On and Off
-
Figure 6
Clean the appliance before turning it on for the first
time. See
Cleaning.
Connect the appliance to the dedicated outlet.
•
To turn the appliance on: Press the On/Off but-
ton until the display lights up.
•
To turn the appliance off: Keep the On/Off
button pressed for three seconds so that the tem-
perature display goes out.
Figure 6