Справочник Пользователя для Master Bilt GT-60

                                                                     

10

 
 
To remove the glass lid,  start in the closed position 
and  lift up on the front  extrusion.  Pull the glass lid 
towards you to remove it from the track.  Reverse 
procedure to reinstall. 
 
 
To remove the top deck, slide (remove) insert strip from 
price tag 
moulding.   Remove screws which are now exposed to 
remove the price tag moulding.  Remove screws on 
sides of the cabinet 
which also attach the top deck.  Reverse procedure to 
reinstall.  
 
 

 
 
 
 
Drain Pan, Light Shield, and Lamp Removal /Replacement 
 

 
To remove the drain pan, remove screws along the 
front face of the drain pan.  Lift the rear of the pan up 
and out of the drain trough.  Slide pan towards you 
and out.  Reverse procedure to install. 
 
To remove the light shield, remove screws along the 
front face of the light shield.  Pull the light shield 
towards you and out.  Reverse procedure to reinstall. 
 
The fluorescent lamps are held in place with spring 
type retainers.  First turn off the lamps at the toggle 
switch or unplug the cabinet from the wall outlet.  To 
remove the lamps push toward the spring-loaded 
retainer until completely compressed and rotate the 
lamp down and out of the fixed retainer.  Installation is 
the reverse of removal. 

With room ambient temperature of +80 

o

F and cold cabinet (unit cycling on control): 

 
Suction pressure – 6 to 8 psig. 
Head pressure – 240 to 260 psig. 
 
If room ambient is low, 60

 o

F or lower, then the suction pressure could be as low as 4 psig.  Temporary block 

the condenser coil to raise head pressure to 240 psig in order to verify proper charge and a suction pressure of 
6psig to 8 psig.  Remove blockage after pressure check.  
 
 
 

Top Deck

Light Shield

Drain Pan 

Price Tag 

Glass Lid