Справочник Пользователя для KitchenAid KGRC608

Скачать
Страница из 28
25
To Replace:
1. Hold oven door by the handle and place the top of the door 
under the cooktop overhang.
2. Use front of leg to apply pressure to slide hinges into the slots 
as far as possible.
3. Use side of leg to apply pressure to the bottom of the door 
front.
4. Lift door slightly. Apply pressure and push until the hinges 
have gone in fully.
5. Fully open the door.
6. Tighten clips with a #2 square or Phillips screwdriver. 
Storage Drawer
The storage drawer can be removed. Before removing, make sure 
drawer is cool and empty.
To Remove:
1. Pull drawer straight out to the first stop.
2. Lift up the back of the drawer and pull out.
To Replace:
1. Fit the ends of the drawer rails into the guides in the cavity.
2. Slide the drawer closed.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of 
an unnecessary service call.
Nothing will operate
Is the power supply cord unplugged?
Plug into a properly grounded 3 prong outlet.
Has a household fuse blown or has the circuit breaker 
tripped?
Replace the fuse or reset the circuit.
Surface burners will not operate
Is this the first time the surface burners have been used?    
Turn on any one of the surface burner knobs to release air 
from the gas lines.
Is the control knob set correctly?
Push in knob before turning to a setting.
Are the burner ports clogged?
On sealed burner models, see “Sealed Surface Burners” 
section.
Surface burner flames are uneven, yellow and/or noisy
Are the burner ports clogged? 
On sealed burner models, see “Sealed Surface Burners” 
section.
On models with caps, are the burner caps positioned 
properly?
See “Sealed Surface Burners” section.
Is the burner damaged?
On models with caps, look for a warped cap. If cap will not 
spin freely on a flat surface, painted side down, the cap is 
warped. Switch cap with a different surface burner to check 
for further warping. Contact a trained repair specialist.
Is propane gas being used?
The appliance may have been converted improperly.    
Contact a trained repair specialist.
Surface burner makes popping noises
Is the burner wet?
Let it dry.
Burner sparks but does not light
Is there continuous sparking, but the burner does not 
light?
Discontinue use of the surface burner and contact a service 
technician.
Excessive heat around cookware on cooktop
Is the cookware the proper size?
Use cookware about the same size as the surface cooking 
area, element or surface burner. Cookware should not extend 
more than 1 in. (2.5 cm) outside the cooking area.