Справочник Пользователя для Siemens FX300
INSTALLATION
3
23
SITRANS FX300
www.siemens.com/flow
06/2009 - SFIDK.PS.050.F2.02 A5E02100423
3.4.5 Turning the connection housing
• Disconnect the power supply from the measuring device.
• Loosen the four screws 1 on the rear side of the connection housing.
• Lift the connection housing and turn it to the required position in 90° steps.
• Screw the connection housing back on.
• Loosen the four screws 1 on the rear side of the connection housing.
• Lift the connection housing and turn it to the required position in 90° steps.
• Screw the connection housing back on.
DANGER!
All work on the device electrics may only be carried out by appropriately trained personnel. The
regional occupational health and safety directives must always be observed.
All work on the device electrics may only be carried out by appropriately trained personnel. The
regional occupational health and safety directives must always be observed.
CAUTION!
Do not damage the electrical cable by overtwisting it.
Do not remove the electrical connector.
Do not damage the electrical cable by overtwisting it.
Do not remove the electrical connector.
Figure 3-5: Allen screws on connection housing
MA_Siemens_Sitrans_FX300_R02_en_PRT.book Page 23 Monday, June 22, 2009 8:17 AM