Справочник Пользователя для Index Interfurn 90-823226
POWER STEERING - 8A-5
90-823226--1 996
Testing and Repair
Refer to appropriate MerCruiser Stern Drive
Service Manual.
Service Manual.
Checking Pump Fluid Level
Refer to Section 1B - “Maintenance” (see “Table of
Contents”).
Contents”).
Filling and Air Bleeding
System
System
Refer to Section 1B - “Maintenance” (see “Table of
Contents”).
Contents”).
Belt Adjustment
V-Belt
IMPORTANT: Do not pry on power steering pump
with pry bar or screwdriver. Serious damage may
result.
with pry bar or screwdriver. Serious damage may
result.
1. Install drive belt on pulleys and adjust tension as
follows:
a. Pivot pump away from engine, as required,
until correct tension is obtained, as shown.
b. After obtaining correct tension, securely
tighten pump brace and pump mounting
bolts.
bolts.
2. If a new drive belt has been installed, recheck belt
tension after running for five minutes.
72847
b
a
a - Belt Should Depress 1/4 In (6 mm)
b - Screws and Nuts
b - Screws and Nuts
Serpentine Belt Adjustment
1. Using a 5/8 inch wrench, loosen the nut on the ad-
justment stud.
2. Place the 5/16 inch deep socket on the hex end
of the adjustment stud rotate starboard tensioner
until there is 1/4 inch (6 mm) deflection is
achieved between the pulleys with the greatest
distance between them (this location may be dif-
ferent with various belt configurations).
until there is 1/4 inch (6 mm) deflection is
achieved between the pulleys with the greatest
distance between them (this location may be dif-
ferent with various belt configurations).
3. While holding adjustment stud at the correct belt
tension, tighten locking nut.
74908
b
a
Bravo Model With Power Steering Shown (Other
Configurations Will Be Different)
Configurations Will Be Different)
a - Locking Nut
b - Adjustment Stud
b - Adjustment Stud
Index