Справочник Пользователя для Pelco CM9700MDD-EVS

38

C1570M-C (5/06)

Once you have configured the CM9700MDD-EVS settings in the CM9700-MGR software, complete the following tasks to transfer the data to the 
matrix system components:

Export the configuration files, and then transfer these files to the CM9700-CC1. These configuration files are named <NodeName>.* 
(each type of configuration file is named with a different extension). 

During the export process, an XML file is created for the CM9700MDD-EVS units on the node (refer to Figure 43); transfer this file, named 
MDD_<NodeName>.xml, to the CM9700MDD-EVS. In a multi-node matrix system, one XML file is created for each node.

Complete the following steps to transfer CM9700MDD-EVS configuration settings to the matrix system:

1. Use the CM9700-MGR Export option (click File > Export To Configuration Files) to export the configuration files. Refer to the Creating 

Configuration Files (Export) for the CC1 section in the CM9700-MGR Software Guide for instructions.

Configuration files can be exported either to a hard drive (either local or network) or to a floppy drive. If you specify a floppy drive for the 
export location, the CM9700-MGR will provide prompts during the export process to insert a floppy disk for the configuration files and a 
floppy disk for the XML file.

Figure 42.  Exporting CM9700-MGR Configuration Files

Figure 43.  CM9700MDD-EVS XML File

2. When the Export process is complete, complete the following tasks:

Transfer the configuration files to the CM9700-CC1, as described in the Copying the Configuration Files to the CC1 section in the 
CM9700-MGR Software Guide. 

Transfer the XML file to the CM9700MDD-EVS through the Endura system, as described in step 3.