Справочник Пользователя для Toshiba 4511

November 2003  ©  TOSHIBA TEC

3 - 13

e-STUDIO3511/4511 ADJUSTMENT

Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.

1. While pressing [0] and [5] simultaneously, turn the power ON.  

→ (Adjustment Mode)

2. Press [3] 

→ [FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from the lower

drawer.)

3. Check the grid pattern on the test print and measure the distance E from the left edge of the

paper to the 6th line of the grid pattern.

4. Check if the distance E is within 52±0.5 mm.

5. If not, use the following procedure to change values and measure the distance E again.

<Procedure>

(Adjustment Mode) 

→ (Key in the code [498]) → [START] → [0] → [START]

→ (Key in a value (acceptable values: 0 to 255))
→ [ENTER]  or [INTERRUPT] (Stored in memory)
→ "100% A" is displayed.
→ Press [3] → [FAX] → (A grid pattern is printed out.)
** The larger the adjustment value is, the longer the distance E becomes (approx.

0.04 mm/step).

1. While pressing [0] and [5] simultaneously, turn the power ON.  

→ (Adjustment Mode)

2. Press [3] 

→ [FAX]. (A grid pattern with 10 mm squares is printed out. Use A4/LT from the upper

drawer.)

3. Check the grid pattern on the test print and measure the distance E from the left edge of the

paper to the 6th line of the grid pattern.

4. Check if the distance E is within 52±0.5 mm.

5. If not, use the following procedure to change values and measure the distance E again.

<Procedure>

(Adjustment Mode) 

→ (Key in the code [498]) → [START] → [1] → [START]

→ (Key in a value (acceptable values: 0 to 255))
→ [ENTER] or [INTERRUPT] (Stored in memory)
→ "100% A" is displayed
→ Press [3] → [FAX] → (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance E becomes (approx.

0.04 mm/step).

04/02