Справочник Пользователя для Mitsubishi Electronics FR-D740-012

Wiring

 Use a bar terminal and a wire with a sheath stripped off for the control circuit wiring. For a single wire, strip off the sheath of
the wire and apply directly.
Insert the bar terminal or the single wire into a socket of the terminal.

1) Strip off the sheath about the size below. If the length of the sheath peeled is too long, a short circuit may occur among

neighboring wires. If the length is too short, wires might come off.

2) Crimp the bar terminal.

 Insert wires to a bar terminal, and check that the wires come out for about 0 to 0.5 mm from a sleeve.

Check the condition of the bar terminal after crimping. Do not use a bar terminal of which the crimping is inappropriate, or
the face is damaged.

Introduced products on bar terminals :(as of Mar., 2008)

Bar terminal crimping tool: CRIMPFOX ZA3 (Phoenix Contact Co., Ltd.)

Recommend wire size:
0.3mm

2

 to 0.75mm

2

0.3, 0.5

AI 0,5-10WH

—

Phoenix Contact Co.,Ltd.

0.75

AI 0,75-10GY

A 0,75-10

1

AI 1-10RD

A1-10

1.25, 1.5

AI 1,5-10BK

A1,5-10

0.75 (for two wires)

AI-TWIN 2 x 0,75-10GY

—

Wire stripping size

10mm

(0.39 inch)