Справочник Пользователя для Navman 4433
Correct installation is critical to the
performance of the FISH 4432/4433. There are
two components to install, the display unit and
performance of the FISH 4432/4433. There are
two components to install, the display unit and
6 Installation and Maintenance
the transducer. It is vital to read the entire
installation section of this manual before
attempting to install the components.
installation section of this manual before
attempting to install the components.
Warning
1 Amp fuses must be positioned where
shown in the wiring diagrams.
shown in the wiring diagrams.
The power/data cable contains 5 wires:
Wire Function
Black
Ground (power negative)
White* NMEA
out
Red
Positive power in, 12 V DC
Yellow
Auto power in (connect to red
wire. Positive power in, to enable
Auto
power).
Green*
External beeper or light out,
switched to ground, 30 V DC 200
mA
maximum.
Note: The cable shield is connected to Pin 1 (black
wire) and does not need to be grounded.
* Denotes FISH 4433 only.
wire) and does not need to be grounded.
* Denotes FISH 4433 only.
Six wiring options are described in this section:
•
Basic wiring. This does not start the fishfinder
automatically when the boat ignition is switched on
and it disables the engine hours counter.
automatically when the boat ignition is switched on
and it disables the engine hours counter.
•
Auto power wiring. This must be used for the
engine hours and fuel computer options.
engine hours and fuel computer options.
•
Secondary Alarm wiring
•
NMEA wiring
•
Single engine fuel wiring
•
Twin engine fuel wiring
Note: If a wire colour is not specifically
mentioned, it is not used in that wiring option.
mentioned, it is not used in that wiring option.
Section 6-5 Systems of several instruments,
describes NMEA and NavBus.
describes NMEA and NavBus.
Wiring Options
Fuse
Red
Yellow
Black
Main
switch
switch
12 V DC
Basic wiring
This requires the FISH 4432 and FISH 4433 to be
powered on manually with the key.
powered on manually with the key.
Black wire: Connect this to the negative
battery terminal.
battery terminal.
Red wire: Connect this to the positive battery
terminal after the main switch. Fit a 1 Amp fuse
as shown.
terminal after the main switch. Fit a 1 Amp fuse
as shown.
Yellow wire: Connect this to the black wire.
This disables the engine hours counter.
This disables the engine hours counter.
Basic wiring
Power on the fishfinder manually whenever the
main switch is on.
main switch is on.
White Wire: Use this, if desired, to connect the fishfinder to other NMEA instruments such as
Navman’s REPEAT 3100. (See section 6-5 Systems of several instruments.)
Navman’s REPEAT 3100. (See section 6-5 Systems of several instruments.)
NMEA wiring Option (FISH 4433 only)
FISH 4432/4433 Installation and Operation Manual
29
NAVMAN