Справочник Пользователя для Mitsubishi Electronics C6/C64

 
 

I - 107 

 

The design of the panel is a very important factor for the EMC countermeasures, so take the following 
countermeasures into consideration. 

 
 

 

(1)  Use metal for all members configuring the panel. 

 

(2)  When joining the top plate and side plates, etc., treat the welded or contacting sections so that the 

impedance is reduced, and then fix with screws. 

 

•  Using screws to fix the plates that have been painted is the same as an insulated state. 

Peel off the paint and fix the screws. 

 

 

Plating mask 

Joining clearance : Approx. 20cm 

 

 

(3)  Note that if the plate warps due to the screw fixing, etc., by that creating a clearance, noise could 

leak from that place. 

 

(4)  Plate (nickel, tin) the metal plate surface at the grounding plate, and connect the connections with 

a low impedance. 

 

(5)  If there is a large opening, such as ventilation holes, make sure to close the hole. 

 

 

Opening 

Mesh cover 
(conductive sponge) 

Control panel