Справочник Пользователя для Standard Horizon CP180i
Page 30
Radar Operation Manual
Figure 4.3.1b - EBL & VRM
4.3.2 Parallel Cursor
A set of parallel lines with first line passing through the ship’s position and next lines being
placed equally spaced and extending from the ship’s position towards one direction.
The user can change the angle of the lines and the range between lines. It is used to
measure the bearing of other boats, navigate at a fixed distance from the coast and measure
the distance between two points.
Parallel Cursor is used to avoid running under a minimum distance from the coast. Let's say
you are navigating parallel to the coast and you need to avoid getting closer than 1000 feet
to it. By properly setting the Parallel Cursor you can may sure that your course will never
take you nearer than 1000 feet from the coast.
placed equally spaced and extending from the ship’s position towards one direction.
The user can change the angle of the lines and the range between lines. It is used to
measure the bearing of other boats, navigate at a fixed distance from the coast and measure
the distance between two points.
Parallel Cursor is used to avoid running under a minimum distance from the coast. Let's say
you are navigating parallel to the coast and you need to avoid getting closer than 1000 feet
to it. By properly setting the Parallel Cursor you can may sure that your course will never
take you nearer than 1000 feet from the coast.
Parallel Cursor
N
E
W
S
Figure 4.3.2 - Parallel Cursor
To turn the Parallel Cursor display On or Off, follow this procedure:
1. Press [MENU]. Move the ShuttlePoint knob to highlight FEATURES and press [ENT].
2. Move the ShuttlePoint knob to highlight PARALLEL CURSOR and press [ENT].
3. Move the ShuttlePoint knob to highlight ON or OFF and press [ENT].
1. Press [MENU]. Move the ShuttlePoint knob to highlight FEATURES and press [ENT].
2. Move the ShuttlePoint knob to highlight PARALLEL CURSOR and press [ENT].
3. Move the ShuttlePoint knob to highlight ON or OFF and press [ENT].
4.3.3 Center Offset
In some cases, the location of the Radar antenna may not be directly on the center line of
the boat. This selection allows you to offset the current position to the center line of the
vessel.
the boat. This selection allows you to offset the current position to the center line of the
vessel.