Справочник Пользователя для Standard Horizon MDS-1
Page 18
Radar Installation Manual
1. From the Chart page, press [MENU]. Move the ShuttlePoint knob to highlight SETUP
MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT].
3. Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT].
4. Move the ShuttlePoint knob to highlight PORT 1 INPUT and press [ENT].
5. Move the ShuttlePoint knob up/down to select RADAR and press [ENT].
6. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
3. Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT].
4. Move the ShuttlePoint knob to highlight PORT 1 INPUT and press [ENT].
5. Move the ShuttlePoint knob up/down to select RADAR and press [ENT].
6. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
2.7.2 CPV350 Connections
A switch MUST be connected
to turn the Radar On or Off
to turn the Radar On or Off
Radar
Switch
Battery Switch
Battery
RADAR CABLE
WIRE COL. FUNCTION
BLACK
BLACK
DATA GROUND
ORANGE
DATA OUT+
YELLOW
DATA OUT-
BROWN
DATA IN+
RED
DATA IN-
GREEN
POWER ON/OFF SWITCH
BLUE
POWER ON/OFF SWITCH
BLACK
RADAR BATTERY GROUND
WHITE
RADAR BATTERY POSITIVE
PLOTTER CABLE
WIRE COLOR FUNCTION
GREEN
GREEN
GND
No connection AUX OUT+
1 OUTPUT+ (TX+)
BLUE (Port 1)
INPUT+ (RX+)
BLACK
POWER- /GND
RED
POWER+
BROWN
(Port
)
Breaker panel
ACC Cable
Figure 2.7.2 - CPV350 Connections