Справочник Пользователя для Broilmaster B101652

B101586-7-1012

Page 15

5. 

For R3 Series Grill Heads: Bend the tabs on the Post Cover 

Plate to 90° as shown in Figure 5. Two different size cover 

plates are included with the R3 Series Grill Heads. Choose 

the plate that will best fit your post. 

 

 

 

Note: If using the stainless steel Post Cover Plate, bend the 

tabs so they face away from the protective film. Remove the 

protective film after bending the tabs.

COVER PLATE

PROTECTIVE

FILM SIDE

6. 

For R3 Series Grill Heads: Slide the Post Cover Plate 

onto the front of the post. Slide the Upper Bracket onto the 

post. Secure the Post Cover Plate and Upper Bracket to the 

top of the square post using four #10 – ½ Self Drill screws 

for stainless steel posts and 10 x 1/2 Hex Head screws for 

black posts. See Figures 5 and 6. 

 

 

 

For Grill Heads other than R3 Series: Slide the Upper 

Bracket into the post. Secure the Upper bracket to the top 

of the square post using four #10 – ½ Self Drill screws. See 

Figure 6.

7.  Position the grill head onto the post and fasten with ¼-20 x ¾ 

Hex Head Screws and 1/4 x 5/8 Flat Washers. See Figure 7.

8.  Arrange with your local gas company or licensed contractor to 

have a gas supply line connected to the inlet of the stainless 

steel flex tube assembly. The gas supply must have a shutoff 

valve that is close to the post in case of emergency and must 

be shutoff when the grill is not in use.

Installing old grill head P3 or P4 to new patio post.
 

A B101668 kit will need to be used to cover the opening in the 

post. See the instructions with the kit for further installation 

information.