Справочник Пользователя для Mitsubishi Electronics QD75P4
9 - 86
MELSEC-Q
9 MAJOR POSITIONING CONTROL
9.2.16 Speed-position switching control (INC mode)
In "speed-position switching control (INC mode)" (" Da.2 Control system" =
Forward run: speed/position, Reverse run: speed/position), the pulses of the speed set
in " Da.8
Forward run: speed/position, Reverse run: speed/position), the pulses of the speed set
in " Da.8
Command speed" are kept output on the axial direction set to the
positioning data. When the "speed-position switching signal" is input, position control of
the movement amount set in " Da.6
the movement amount set in " Da.6
Positioning address/movement amount" is
exercised.
"Speed-position switching control (INC mode)" is available in two different types:
"forward run: speed/position" which starts the axis in the forward run direction and
"reverse run: speed/position" which starts the axis in the reverse run direction.
Use the detailed parameter 1 " Pr.150 Speed-position function selection" with regard
to the choice for "speed-position switching control (INC mode)".
"Speed-position switching control (INC mode)" is available in two different types:
"forward run: speed/position" which starts the axis in the forward run direction and
"reverse run: speed/position" which starts the axis in the reverse run direction.
Use the detailed parameter 1 " Pr.150 Speed-position function selection" with regard
to the choice for "speed-position switching control (INC mode)".
Setting item
Setting
value
Setting details
Buffer memory address
Axis 1 Axis 2 Axis 3
Axis 4
Pr.150
Speed-
position
function
selection
position
function
selection
0
Speed-position switching control
(INC mode)
(INC mode)
34 184 334
484
If the set value is other than 0 and 2, it is regarded as 0 and operation is performed in the
INC mode.
For details of the setting, refer to Section 5.2 "List of parameters".
For details of the setting, refer to Section 5.2 "List of parameters".
Switching over from speed control to position control
(1) The control is switched over from speed control to position control by
executing the external command signal set in "speed-position switching signal".
(2) Besides setting the positioning data, the " Cd.24 Speed-position switching
enable flag" must also be turned ON to switch over from speed control to
position control. (If the " Cd.24 Speed-position switching enable flag" turns
ON after the speed-position switching signal turns ON, the control will continue
as speed control without switching over to position control. The control will be
switched over from speed control to position control when the speed-position
switching signal turns from OFF to ON again. Only position control will be
carried out when the " Cd.24 Speed-position switching enable flag" and
speed-position switching signal are ON at the operation start.)
position control. (If the " Cd.24 Speed-position switching enable flag" turns
ON after the speed-position switching signal turns ON, the control will continue
as speed control without switching over to position control. The control will be
switched over from speed control to position control when the speed-position
switching signal turns from OFF to ON again. Only position control will be
carried out when the " Cd.24 Speed-position switching enable flag" and
speed-position switching signal are ON at the operation start.)
Setting item
Setting
value
Setting details
Buffer memory address
Axis 1 Axis 2 Axis 3
Axis 4
Cd.24
Speed-
position
switching
enable
flag
position
switching
enable
flag
1
Set "1: Switch from speed control
to position control when the
external command signal [CHG]
turns ON.".
to position control when the
external command signal [CHG]
turns ON.".
1528 1628 1728
1828