Справочник Пользователя для Mitsubishi Electronics QD75D2
6 - 5
MELSEC-Q
6 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL
6.2 List of devices used
In the sequence programs shown in this chapter and subsequent, the application of the
devices used are as follows.
The I/O numbers for QD75 indicate those when QD75 is mounted in the 0-slot of the
main base.
If it is mounted in the slot other than the 0-slot of the main base, change the I/O
number to that for the position where QD75 was installed.
In addition, change the external inputs, external outputs, internal relays, data resisters,
and timers according to the system used.
devices used are as follows.
The I/O numbers for QD75 indicate those when QD75 is mounted in the 0-slot of the
main base.
If it is mounted in the slot other than the 0-slot of the main base, change the I/O
number to that for the position where QD75 was installed.
In addition, change the external inputs, external outputs, internal relays, data resisters,
and timers according to the system used.
(1) Inputs/outputs, external inputs/external outputs, and internal relays
of QD75
Device
name
Device
Application
Details when ON
Axis 1 Axis 2 Axis 3 Axis 4
Inputs/
outputs
of
QD75
Input
X0
QD75 READY signal
Preparation completed
X1
Synchronization flag
QD75 buffer memory accessible
X4
X5
X6
X7 M code ON signal
M code outputting
X8
X9
XA
XB Error detection signal
Error detected
XC
XD
XE
XF BUSY signal
BUSY (operating)
X10
X11
X12
X13 Start complete signal
Start completed
X14 X15 X16 X17
Positioning
complete
signal
Positioning
completed
Out-
put
Y0
PLC READY signal
CPU module preparation completed
Y4
Y5
Y6
Y7 Axis stop signal
Requesting stop
Y8
YA
YC
YE Forward run JOG start signal
Starting forward run JOG
Y9
YB
YD
YF Reverse run JOG start signal
Starting reverse run JOG
Y10 Y11 Y12 Y13
Positioning
start
signal
Requesting
start
External
input
(command)
X20
—
OPR request OFF command
Commanding OPR request OFF
X21
External command valid command
Commanding external command valid
setting
setting
X22
External command invalid command
Commanding external command
invalid
invalid
X23
Machine OPR command
Commanding machine OPR
X24
Fast OPR command
Commanding fast OPR
X25
Positioning start command
Commanding positioning start
X26
Speed-position switching operation
command
command
Commanding speed-position switching
operation
operation
X27
Speed-position switching enable
command
command
Commanding speed-position switching
enable command
enable command
X28
Speed-position switching prohibit
command
command
Commanding speed-position switching
prohibit
prohibit
X29
Movement amount change command
Commanding movement amount
change
change
X2A
High-level positioning control start
command
command
Commanding high-level positioning
control start
control start
X2B
Positioning start command (dedicated
instruction)
instruction)
Commanding positioning start