Справочник Пользователя для Mitsubishi Electronics E60

I - 12 

 

This indicates that automatic operation stopped after executing 
one block of the program. 

Error No. 

Details 

Remedy 

SNGL BLK ON (Single block on)  

The SINGLE BLOCK switch on the 
machine operation panel is ON. 

The single block or machine lock switch 
changed. 

•  Automatic operation can be resumed by 

turning the CYCLE START switch ON. 

User macro stop 

The block stop command was issued in 
the user macro program. 

•  Automatic operation can be resumed by 

turning the CYCLE START switch ON. 

Mode change 

The automatic mode changed to another 
automatic mode. 

•  Return to the original automatic 

operation mode‚ and resume automatic 
operation by turning the CYCLE START 
switch ON. 

MDI completion 

The last block of MDI was completed. 

•  Set MDI again‚ and turn the CYCLE 

START switch ON to resume MDl 
operation. 

Block start interlock 

The interlock signal that locks the block 
start is entered. 

•  Check the sequence program. 

Block cutting start interlock 

The interlock signal that locks the block 
cutting start is entered. 

•  Check the sequence program. 

Offset change of inclined Z-axis during 
program operation 

Whether to validate the offset of the 
inclined Z-axis switched during program 
operation. 

•  Automatic operation can be restarted by 

turning ON the cycle start switch. 

 
 

Collation stop was applied during automatic operation. 

Error No. 

Details 

Remedy 

Collation stop occurred. 

•  Automatic operation can be restarted 

with automatic start.