Справочник Пользователя для Mitsubishi Electronics E60

I - 42 

Error Message 

Error 

No. 

Details Remedy 

–4 

Communication ends with timeout. 

CNC has a 248-byte receive buffer. 

The time during which CNC receives 

248 bytes exceeds the "TIME-OUT" 

value set in the I/O device parameter.

 

1)  Set a greater timeout value in the 

input/output device parameter. 

2)  Recheck the HOST software as to 

whether or not the HOST transmits 
data in response to DC1 from CNC 
(data request). 

3)  Check whether or not start code of 

computer link parameter is set to 0. 

–10  HOST ER (CNC DR) signal is not turned 

ON. 

1)  Check whether or not the cable is 

disconnected from the connector. 

2)  Check whether or not the cable is 

broken. 

3)  Check whether or not the HOST power 

is turned ON. 

–15  Communication ends with parity H. 

1)  Recheck the HOST software as to 

whether or not the data to be 
transmitted to CNC is ISO code. 

–16  Communication ends with parity V. 

1)  Recheck the data to be transmitted to 

CNC. 

DNC ERROR 

–17  Although CNC transmits DC3 (request to 

stop data transfer) to the HOST, it 
receives data of 10 bytes or more from 
the HOST, thus terminates 
communication. 
When CNC is transmitting data to the 
HOST, it receives data of 10 bytes or 
more from the HOST. 

1)  Recheck the software as to whether or 

not the HOST stops transmitting data 
within 10 bytes after receiving DC3. 

2)  Recheck the HOST software as to 

whether or not the HOST transmits 
data such as a command or header to 
CNC during receiving a work program.