Справочник Пользователя для Mitsubishi Electronics AJ65BT-D75P2-S3
5 - 90
MELSEC-A
5 DATA USED FOR POSITIONING CONTROL
5.6.2 Axis monitor data
Storage item
Storage details
Md.29
System-used area
Md.30 Machine feed value
The address of the current position obtained with the machine coordinates is
stored. (Different from the actual motor position during operation)
The machine feed value is not changed by the current value change function.
Updated during speed control regardless of the parameter setting.
Not cleared to 0 when fixed-dimension feed is started.
Does not change into the ring address of 0 to 359.99999 in the "degree" unit.
stored. (Different from the actual motor position during operation)
The machine feed value is not changed by the current value change function.
Updated during speed control regardless of the parameter setting.
Not cleared to 0 when fixed-dimension feed is started.
Does not change into the ring address of 0 to 359.99999 in the "degree" unit.
Machine coordinates: Characteristic coordinates determined with machine
Update timing: 56.8ms
Md.31
to
Md.35
System-used area
Md.36 Current speed
" Da.7 Command speed" of positioning data currently execution is stored.
When "–1" is set for " Da.7 Command speed": The command speed of the
previous positioning data is stored.
When a value other than "–1" is set for " Da.7 Command speed": The
command speed of the positioning data currently being executed is stored.
When the speed change function is executed : "New speed value (RWwm+4 to
5, RWwm+12 to 13)" is stored. (For details of the speed change function, refer
to Section 12.5.1.)
to Section 12.5.1.)