Справочник Пользователя для GTO R4854 01

  GTO 4000XLS Instruction Manual © 01.10.12  

RED wire to POSITIVE (+) terminal

BLACK wire to NEGATIVE (–) terminal

RED

BLACK

IMPORTANT: Connect the BLACK battery wire to the NEGATIVE (–) 

battery terminal. Connect the RED battery wire to the POSITIVE (+)

terminal. Reverse connection of battery wires will damage the 

control board. 

Plug the transformer 

into the electrical outlet. (Use of a surge protector with the 

transformer is strongly recommended.) IMPORTANT: This is a 

class II indoor transformer; if using transformer outdoors be sure 

to enclose it in a weatherproof case.

Power switch is on, gate 

is in the OPEN position, 

operator arm 

fully retracted.

Press the transmitter to 

activate operator arm.  

The gate will begin 

to CLOSE.

When the gate reaches 

the desired CLOSED 

position, press 

the transmitter 

to stop the gate.

With the gate at the 

correct position, 

program the closed 

limit setting by 

pressing and holding 

LEARN MAST LIMIT.

Control

Box

Control

Box

Control

Box

Control

Box

Press the transmitter 

again to allow the gate 

to return to 

the fully OPEN 

position.

The gate closed position is now programmed.   

If you make a mistake and set the limit at the 

wrong position:  press your transmitter to return 

the gate to the fully opened position, then press 

and hold the LEARN MAST LIMIT button for 5 

seconds. This will clear the memory for the closed 

limit position. Repeat Steps 1-5.