Справочник Пользователя для Graco 4033

To install parking stands (two

in the front, one in the back),

lift base slightly, depress

button on front of stands and

push stands up until they

snap into place.

To use parking stands, lift base

slightly and push stands down

until they snap into place.

To release parking stands,

lift base slightly and depress

button on front of stands.

Push stands upward into

storage position.

!! When parking stands are in use, it is still possible

for your child to move the activity center.

!! Be sure to engage both parking stands.
!! Never place the activity center on a table or

countertop.

To Use Parking Stands

Remove

your child from the

activity center before

making any adjustments.

To raise or lower your

activity center:
Push up button at front of

tray as shown and hold it.
Push down or pull up while

adjusting to desired height.
Tray should lower easily.

DO NOT force tray down

or unit could be damaged.

To Adjust the Activity Center

Avoid

serious injury or death.

DO NOT use product

without the five friction

strips under the base.

!! Make sure strips are

kept clean.

!! Clean strips with

WATER ONLY.

Friction Strip Feature

Caring for the Activity Center

Make sure five friction strips under base are kept

clean. Clean with water only.
To wash fabric seat, unhook the eight grommets

under tray and lift seat off. Machine wash in

lukewarm water on delicate setting and drip dry.

NO BLEACH.
For cleaning metal and plastic parts other than

friction strips, use only household soap or

detergent and warm water. NO BLEACH.
Excessive exposure to sun or heat could cause

fading or warping of parts.

Friction strips under base

Line up the pegs on the

bottom of the spoiler with

the two holes at the back of

the activity center and push

the spoiler in until it snaps

in place. It will not be

removable.
Do not allow spoiler to

block seat by inserting it

backwards.

To Attach the Spoiler

Avoid falls and other hazards. Never

allow unit to be pushed while child is in product.

Step 1.

With the playtray upside down, insert two AA batteries

(we recommend alkaline disposables) into the bottom of

the playtray following the molded directions for placement.

CHECK that the batteries are put in correctly. Your

playtray will not function if the batteries are put in

backwards.

Step 2.

To attach the battery

compartment door, line

up the tabs and set the

door in place as shown.

Step 3.

Close the door and tighten

the attached screw to hold

door closed.

Step 5.

Fasten the playtray to the

activity center by placing

it on the front of the tray

as shown and snapping

the two mounting hooks

onto the activity center

tray. CHECK that the

playtray is securely

fastened to the activity

center tray.

To Assemble the Playtray

Before assembling, check that you have all the

parts listed below:

Playtray

Playtray mounting

hooks (2)left and

right are not the same

Screw (4)

DO NOT lift this product by the playtray.

Door

Keep the batteries out of childrens reach.
Any battery may leak battery acid if mixed with

a different battery type, if inserted incorrectly

(put in backwards) or if all batteries are not

replaced or recharged at the same time.
Any battery may leak battery acid or explode

if disposed of in fire or an attempt is made to

charge a battery not intended to be recharged.

Never recharge a cell of one type in a

recharger made for a cell of another type.
Discard leaky batteries immediately. Leaky

batteries can cause skin burns or other

personal injury. When discarding batteries, be sure to dispose

of them in the proper manner, according to your state and

local regulations.
Always remove batteries if the playtray is not going to be used

for a month or more. Batteries left in the unit may leak and

cause damage.

FOR SAFE BATTERY USE:

Recommended type batteriesalkaline disposables, size AA.

NEVER mix battery types.

Change batteries when playtray ceases to operate satisfactorily.

Replacement Parts

Instructions for ordering activity center parts:

Complete form below. Your activity center model

number MUST be included on the form to ensure

proper replacement parts. Your model number can

be found on a sticker on the underside of the tray.

Payment must accompany your order.

Return the form below with payment to:

GRACO CHILDRENS PRODUCTS INC.

CUSTOMER SERVICE DEPARTMENT

P.O. BOX 100, MAIN STREET

ELVERSON, PA 19520

IF YOU NEED HELP

If you have any questions or if you need any parts

not listed, please call toll-free:

1-800-345-4109

or visit our Internet website, www.gracobaby.com.

Model Number

(Must be filled in)

SHIP TO:

Name

Address

City, State, Zip

( )

Telephone

Account #:

Expiration date:
Signature:

Total:
Shipping

& handling*: $5.00
6% sales tax

(PA only):
Total amount

due:

*Outside the continental U.S., please

call for shipping cost.

Seat

Seat back

Caster

Rear wheel

Parking stand

Skid strip

Playtray

Mounting hooks

Spoiler

Parts List:

Seat ...................................

Seat back ...........................

Caster ................................

Rear wheel ..............................

Parking stand ....................

Skid strip ...........................

Pin .....................................

Playtray ...............................

Mounting hooks (both) .........

Spoiler ..................................

Price:*

$13.00

$ 5.00

$ 5.00 (each)

$ 8.00 (each)

$ 5.00 (each)

No charge

$20.00

$ 5.00

$ 7.00

* Prices subject to change without notice.

Check enclosed

(payable to Graco Childrens

Products Inc.)
Charge to credit card:

Visa

MasterCard

Discover

308-2-00 308999

Step 4.

Attach the right and left

mounting hooks to the

underside of the playtray

with the four screws

provided. The mounting

hooks will only fit one

way.

To Attach the Decal

Place decal on front of

the base as shown. Rub

over decal with hand

or clean cloth to

assure adhesion.