Справочник Пользователя для Renesas R5S72646
Section 20 Controller Area Network
R01UH0134EJ0400 Rev. 4.00
Page 1077 of 2108
Sep 24, 2014
SH7262 Group, SH7264 Group
20.5
Interrupt Sources
Table 20.2 lists this module interrupt sources. These sources can be masked. Masking is
implemented using the mailbox interrupt mask registers (MBIMR) and interrupt mask register
(IMR). For details on the interrupt vector of each interrupt source, see section 7, Interrupt
Controller.
implemented using the mailbox interrupt mask registers (MBIMR) and interrupt mask register
(IMR). For details on the interrupt vector of each interrupt source, see section 7, Interrupt
Controller.
Table 20.2 Interrupt Sources
Interrupt Description
Interrupt Flag
DMAC Activation
ERSn*
1
Error Passive Mode (TEC
128 or REC 128) IRR5
Not possible
Bus Off (TEC
256)/Bus Off recovery
IRR6
Error warning (TEC
96)
IRR3
Error warning (REC
96)
IRR4
OVRn*
1
Reset/halt/CAN sleep transition
IRR0
Overload frame transmission
IRR7
Unread message overwrite (overrun)
IRR9
Start of new system matrix
IRR10
TCMR2 compare match
IRR11
Bus activity while in sleep mode
IRR12
Timer overrun/Next_is_Gap reception/message
error
error
IRR13
TCMR0 compare match
IRR14
TCMR1 compare match
IRR15
RM0n*
1
*
2
,
RM1n*
1
*
2
Data frame reception
IRR1*
3
Possible*
4
Remote frame reception
IRR2*
3
SLEn*
1
Message transmission/transmission disabled
(slot empty)
(slot empty)
IRR8 Not
possible
Notes: 1. n = 0, 1
2. RM0 is an interrupt generated by the remote request pending flag for mailbox 0
(RFPR0[0]) or the data frame receive flag for mailbox 0 (RXPR0[0]). RM1 is an interrupt
generated by the remote request pending flag for mailbox n (RFPR0[n]) or the data
frame receive flag for mailbox n (RXPR0[n]) (n = 1 to 31).
generated by the remote request pending flag for mailbox n (RFPR0[n]) or the data
frame receive flag for mailbox n (RXPR0[n]) (n = 1 to 31).
3. IRR1 is a data frame received interrupt flag for mailboxes 0 to 31, and IRR2 is a remote
frame request interrupt flag for mailboxes 0 to 31.
4. The direct memory access controller is activated only by an RM0n interrupt.