Справочник Пользователя для Invacare PHWH93

SECTION 6—FRONT RIGGINGS

Adjusting the Angle of the Manual Center Mount
Footrest

WARNING

While the wheelchair is moving, minimum ground clearance for the front rigging is

three inches. If the wheelchair is not moving, the front rigging MUST maintain a

minimum of one inch ground clearance - otherwise personal injury and damage may

result.

NOTE: For this procedure, refer to FIGURE 6.8 on page 23 and FIGURE 6.9.

1. Engage the release lever with one hand

(not shown) and move the center
mount footrest to the desired angle
with the other hand.

NOTE: Refer to FIGURE 6.8 on page 23 for
the location of the release lever.

2. Disengage the release lever (not

shown) to lock the center mount
footrest in the new position.

FIGURE 6.9 Adjusting the Angle of the

Adjusting the Footplate Angle

After 2/14/07

NOTE: For this procedure, refer to FIGURE 6.10.

1. Loosen, but DO NOT remove, the two

rear mounting screws and side
mounting screw.

2. Move the footplate to the desired angle.

3. Tighten the two rear mounting screws

and side mounting screw to secure the
footplate in the desired position.

4. Repeat STEPS 1 and 2 for the other

footplate.

FIGURE 6.10 Adjusting the Footplate

Footplate

Center Mount

Footrest

Center Mount

Front Rigging

Footplate

Side Mounting

Screw

Rear Mounting

Screws