Справочник Пользователя для Exmark LAZER Z HP
- 37 -
g)
Adjust anti-scalp rollers for Normal Operating Conditions. Place rollers in one
of the positions shown in Figure 11. Rollers will maintain 3/4 in. (19 mm)
clearance to the ground to minimize gouging and roller wear or damage.
of the positions shown in Figure 11. Rollers will maintain 3/4 in. (19 mm)
clearance to the ground to minimize gouging and roller wear or damage.
For Maximum Deck Flotation, place rollers one hole position lower.
Rollers should maintain 1/4 in. (6.4 mm) clearance to ground. Do Not
adjust rollers to support the deck. Be sure roller bolts and nuts are
installed with the spring disc washer between head of the bolt and
mounting bracket.
Rollers should maintain 1/4 in. (6.4 mm) clearance to ground. Do Not
adjust rollers to support the deck. Be sure roller bolts and nuts are
installed with the spring disc washer between head of the bolt and
mounting bracket.
Two types of anti-scalp roller assemblies are available. See Figure 11 to
determine which assembly has been installed on the unit. Torque
hardware as specified, or loss of roller may result.
determine which assembly has been installed on the unit. Torque
hardware as specified, or loss of roller may result.
Type A – Torque the 3/8 whizlock nut to 40-45 ft-lbs. (54-61 N-m)
Type B – Torque the 3/8 nyloc nut to 30-35 ft-lbs. (41-47 N-m)
Torque the 3/8-24x2 Gr 8 hex capscrew to 50-55 ft-lbs (68-75 N-m)
FIGURE 11
ANTI-SCALP ROLLER ADJUSTMENT
5.2.2
Deck Leveling
a)
Position mower on a flat surface.
b)
Stop engine, wait for all moving parts to stop, and remove key.
c)
Check tire pressure in drive tires. Proper inflation pressure for tires is 13 psi
(90 kPa). Adjust if necessary.
(90 kPa). Adjust if necessary.
d)
Set anti-scalp rollers to top holes or remove them completely for this adjustment.
e)
Raise the deck to the 5” (12.7 cm) height position (also transport position)
and take all force off of the two large deck lift springs by loosening the nuts
at the front of each spring. See Figure 12.
and take all force off of the two large deck lift springs by loosening the nuts
at the front of each spring. See Figure 12.
f)
For 52” and 60” units - Lower the deck to the 1-1/2” (3.81 cm) height position.
For 72” units – Lower the deck to the 1-1/2” (3.81 cm) height position. Force
the left rear deck support arm downward about 1/4” (6.4 mm) to get the deck
to rest at the 1-1/2” height position. Place locking pliers between the rear
swivel and spring stop to hold the deck in this position. See Figure 12.
the left rear deck support arm downward about 1/4” (6.4 mm) to get the deck
to rest at the 1-1/2” height position. Place locking pliers between the rear
swivel and spring stop to hold the deck in this position. See Figure 12.
g)
Place a 3/4” (19 mm) thick block of wood under each of the two (2) rear
anti- scalp roller brackets and place one under one of the front center
anti-scalp roller brackets.
anti- scalp roller brackets and place one under one of the front center
anti-scalp roller brackets.