Справочник Пользователя для Yamaha HTR-6160
118
En
Troubleshooting
After AUTO SETUP
• If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “AUTO SETUP” again.
• If a warning message “W-1”, “W-2” or “W-3” appears, corrections are made, but they may not be optimal.
• If an error message “E-10” occurs repeatedly, contact a qualified Yamaha service center.
• If a warning message “W-1”, “W-2” or “W-3” appears, corrections are made, but they may not be optimal.
• If an error message “E-10” occurs repeatedly, contact a qualified Yamaha service center.
Warning message
Cause
Remedy
See
page
W-1:OUT OF PHASE
Speaker polarity is not correct. This message
may appear depending on the speakers even
when the speakers are connected correctly.
may appear depending on the speakers even
when the speakers are connected correctly.
Check the speaker connections for proper
polarity (+ or –).
polarity (+ or –).
W-2:OVER 24m (80ft)
The distance between the speaker and the
listening position is over 24 m (80 ft).
listening position is over 24 m (80 ft).
Bring the speaker closer to the listening
position.
position.
—
W-3:LEVEL ERROR
The difference of volume level among
speakers is excessive.
speakers is excessive.
Readjust the speaker installation so that all
speakers are set in locations with similar
conditions.
speakers are set in locations with similar
conditions.
—
Check the speaker connections.
Use speakers of similar quality.
—
When “SWFR: TOO LOUD”or “SWFR:
TOO LOW” appears in the result screen, the
output volume of the subwoofer.
TOO LOW” appears in the result screen, the
output volume of the subwoofer.
W-4:CHECK PRNS
“EXTRA SP ASSIGN” is set to
“PRESENCE”, though the presence channel
signals are not detected.
“PRESENCE”, though the presence channel
signals are not detected.
Check the presence speaker connections.
Set “EXTRA SP ASSIGN” to a setting other
than “PRESENCE”.
than “PRESENCE”.
Notes