Справочник Пользователя для Brother XL-2620
KNOWING YOUR SEWING MACHINE ——————————————————————————————————————————————
16
THREADING THE MACHINE
Winding the Bobbin
1Pre-tension disk
2Bobbin winder shaft
2Bobbin winder shaft
1
Put the spool of thread on the spool pin and
pass the thread around the pre-tension disk.
pass the thread around the pre-tension disk.
2
Pass the end of the thread through the hole on
the bobbin from the inside of the bobbin.
the bobbin from the inside of the bobbin.
3
Put the bobbin onto the bobbin winder shaft
and slide the bobbin winder shaft to the right.
Turn the bobbin clockwise, by hand, until the
spring on the shaft slides into the groove of
the bobbin.
and slide the bobbin winder shaft to the right.
Turn the bobbin clockwise, by hand, until the
spring on the shaft slides into the groove of
the bobbin.
1 Spring on the shaft
2 Groove of the bobbin
2 Groove of the bobbin
●
Only use bobbins (part code: SA156, SFB (XA5539-151)) that have been designed for this
sewing machine. Using other bobbins may cause damage to the machine.
sewing machine. Using other bobbins may cause damage to the machine.
●
We designed the bobbin that comes with this machine. If you use bobbins from other models,
the machine will not work properly. Only use the bobbin that comes with this machine or
bobbins of the same type (part code: SA156, SFB (XA5539-151)).
the machine will not work properly. Only use the bobbin that comes with this machine or
bobbins of the same type (part code: SA156, SFB (XA5539-151)).
CAUTION
Actual size
This model
Other models
11.5 mm
(7/16 inch)
1
2
●
If the spool of thread is not in the right
place, the thread may tangle on the spool
pin.
place, the thread may tangle on the spool
pin.
CAUTION
1
2
XL2600.book Page 16 Thursday, November 4, 2004 9:46 PM