Справочник Пользователя для Shark V1950Q

1. Charge for a minimum of 20 hours before initial use.  Failure to do so will reduce 

the product’s battery life significantly.

2. Do not store the unit with the charging adaptor attached and plugged in.
3. Only recharge when the batteries are fully discharged (or as close to fully 

discharged as possible).

4. Do not store in areas of high temperature or humidity.
5. After three (3) months of storage, the product should be fully discharged and then 

recharged to maximize battery power.

6. Use only the charger supplied with the product.  If other chargers are used, the 

batteries can fail causing damage to the battery, product or personal property. 

7. Ni-Cd batteries have a long useful life but at some time they will need to be 

replaced.  To purchase replacement batteries and parts call Customer service at 
1 (800) 79-7398.

: If the product has never been used or has been stored for an extended period of 

time without use – it will take several complete charge and discharge cycles to realize the 
full operational time of your product.

If uncertain as to how to remove your battery pack, we suggest you take your 

sweeper to a reputable small appliance service technician to have this service 
performed.

Follow the steps in “Removal of Battery Pack” when battery removal is required. 

This sweeper is equipped with Ni-Cd batteries and you need to dispose of them properly. 
When the batteries are no longer good for use, they must be removed from the sweeper 
for disposal.  Do not remove the batteries for any reason other than disposal of them. 
Call your nearest recycling center for information on the recycling and disposal of 
Ni-Cd batteries.

Warning: 

You must never use ordinary batteries for replacement as these may leak and 

cause damage.  Use only battery pack XB1918 provided for replacement.

1. Press the dust cup release lever with your foot and remove it from the sweeper 

power head.

2. Turn unit over so that the base is facing upwards.  Be careful not to turn the unit “ON”. 
3. Push in locking tab and lift off battery compartment cover. (Fig. 5 & 6)

4. Carefully lift out the battery pack and disconnect the wire terminals by pulling apart 

the wire terminal connectors.  Remove the battery pack from the unit. (Fig. 7)

5. Connect the wire terminal connector from the unit to the  wire terminal connector of 

the new battery pack, and replace the battery pack into the unit.  Replace the cover 
and press until it snaps in place.

6.  Follow instructions for initial battery charging.  Please call customer service at 

1 (800) 798-7398 if there are any problems removing batteries.

Do NOT attempt to replace the batteries used in this product with any other type of 
battery.

1. Before using, please ensure that the cordless sweeper has been initially 

charged for 20 hours.
Your cordless sweeper will only operate properly when the batteries are fully 
charged.  Your sweeper will operate for varying lengths of time on a full charge. 
This will depend upon the type of surface being cleaned.  (Longer operating time on 
bare floors vs. carpets.)

2. Push the On/Off switch to operate the unit.  To turn off, press switch again. (Fig. 8)