Справочник Пользователя для Desa HRB3624

www.desatech.com

119426-01A

Manual Mode

1. Press the POWER and LOCK buttons together

to turn on the hand-held remote control.

2. Press the MANU button to turn on the

fireplace.

3. Press the POWER and LOCK buttons

together to turn off the fireplace.

Auto (Thermostatic) Mode

1. Press the POWER and LOCK buttons together

to turn on the hand-held remote control.

2. Press AUTO button to select this mode.

3. Set the desired room temperature by press-

ing the TEMP + or - buttons.

4. Press the POWER and LOCK buttons

together to turn off the fireplace

Note:

Do not leave the hand-held remote in the

AUTO mode close to the fireplace. The radiant

heat from the fireplace will turn off the fireplace.

Ideally, place the hand-held remote in the center

of the room facing towards the fireplace.
Note:

Do not hold the hand-held remote for

a long time. Body temperature will affect its

operation in the AUTO mode.
Safety Features

When away from home for an extended period

of time or as a child safety feature to prevent

accidental ignition of the fireplace, the receiver

ON/OFF/REMOTE switch should be in the

OFF position.
Auto Shutoff Feature

1. If the average room temperature exceeds

82 degrees Fahrenheit (28 degrees Centi-

grade), the hand-held remote control will

perform a safety override and shut the

fireplace off. This feature is not available

in the MANU mode.

2. The receiver continuously receives signals

from the hand-held remote to control the

room temperature. If the hand-held remote

is misplaced, obstructed or for any reason

cannot transmit to the receiver, the receiver

will shut off the fireplace after 8 minutes.

Key Pad Lock Feature

This feature allows the user to lock/unlock

the keypad on the hand-held remote in the

MANU or AUTO mode to prevent inadvertent

operation (i.e. children operating the hand-held

remote control, etc.). The keypad is locked in

either on or off. Press the POWER and LOCK

buttons together to turn the unit on or off.

OPERATING HEATER

Continued

INSPECTING bURNERS

Check pilot flame pattern and burner flame pat-

terns often.

PILOT FLAME PATTERN

Figure 36 shows a correct pilot flame pattern.

Figure 37 shows an incorrect pilot flame pattern.

The incorrect pilot flame is not touching the

thermocouple. This will cause the thermocouple

to cool. When the thermocouple cools, the heater

will shut down.

If pilot flame pattern is incorrect, as shown in

Figure 37

• turn heater off (see To Turn Off Gas to Appli-

ance, page 21 [Thermostatically-Controlled

Models] or page 23 [Remote-Ready Models])

• see Troubleshooting, page 28
Note:

The pilot flame on natural gas units will

have a slight curve, but flame should be blue and

have no yellow or orange color.

Figure 36 - Correct Pilot Flame Pattern

(Your pilot may vary from pilots shown)

Pilot Burner

Thermocouple

Figure 37 - Incorrect Pilot Flame Pattern

(Your pilot may vary from pilots shown)

Thermocouple

Pilot Burner