Справочник Пользователя для Hoshizaki KM-1301SAH-E

Скачать
Страница из 59
55
VI. Cleaning and Maintenance
This icemaker must be cleaned and maintained in accordance with the documentation 
and labels provided with the icemaker. Consult with your local distributor about cleaning 
and maintenance service. To obtain the name and phone number of your local distributor, 
contact your nearest Hoshizaki Service office (listed in the Instruction Manual and at  
www.hoshizaki.com).
 WARNING
1. Except as specified below, only qualified service technicians should attempt 
to service this icemaker.
2.
 CHOKING  HAZARD: Ensure all components, fasteners, and thumbscrews 
are securely in place after any cleaning or maintenance is done to the unit. 
Make sure that none have fallen into the storage bin.
3. This appliance must not be cleaned by use of a water jet.
4. To prevent possible damage, do not clean the plastic parts with water above 
104°F (40°C) or in a dishwasher.
5. The storage bin is for ice use only. Do not store anything else in the storage 
bin.
A. Cleaning and Sanitizing Instructions
Performed by Qualified Service Technician
Hoshizaki recommends cleaning and sanitizing this unit at least once a year. More 
frequent cleaning and sanitizing, however, may be required in some existing water 
conditions.
 WARNING
1. To prevent injury to individuals and damage to the icemaker, do not use 
ammonia type cleaners.
2. Carefully follow any instructions provided with the bottles of cleaning and 
sanitizing solution. 
3. Always wear liquid-proof gloves and goggles to prevent the cleaning and 
sanitizing solutions from coming into contact with skin or eyes.
4. To prevent damage to the water pump seal, do not operate the icemaker with 
the control switch in the "WASH" position when the water tank is empty.
1. Cleaning Procedure
1) Dilute 27 fl. oz. (800 ml) of Hoshizaki "Scale Away" with 5 gal. (19 l) of warm water.
2) Remove all ice from the evaporator and the storage bin.
Note: To remove cubes on the evaporator, turn off the power supply and turn it back on 
after 3 minutes. The harvest cycle starts and the cubes will be removed from the 
evaporator.
3) Turn off the power supply.
4) Remove the front panel, then remove the insulation panel by first removing the 
thumbscrew, lifting up the panel slightly and pulling it towards you.