Справочник Пользователя для Philips DVP3126K/61
40
Troubleshooting
Problem
Solution
WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate
the warranty. Do not open the system as there is a risk of electric shock.
Under no circumstances should you try to repair the system yourself, as this will invalidate
the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, fi rst check the points listed below before taking the system for repair. If
you are unable to remedy a problem by following these hints, consult your dealer or
Philips for help.
you are unable to remedy a problem by following these hints, consult your dealer or
Philips for help.
No power.
Remote control does not work.
No picture.
The picture is distorted or black
& white during playback.
& white during playback.
No sound.
– Press STANDBY-ON button on the front of the
DVD player to turn on the system.
– Make sure the AC outlet has power.
– Aim the remote control directly at the sensor on
the front of the DVD player (not towards TV).
– Remove any obstacles between DVD player and
the remote control.
– Batteries are weak, replace the batteries.
– Check the polarities of the batteries are as
– Check the polarities of the batteries are as
indicated on the remote control (± signs).
– Turn on your TV and set to the correct Video In
channel for the DVD player. You may go to
Channel 1 on your TV, then press the channel
down button on your TV’s remote control until
you see the TV program.
Channel 1 on your TV, then press the channel
down button on your TV’s remote control until
you see the TV program.
– Check the video connection between the DVD
player and the TV.
– The disc does not match with the TV color system
standard (PAL/NTSC).
– The disc is dirty, clean the disc.
– Sometimes a small amount of picture distortion
– Sometimes a small amount of picture distortion
may appear. This is not a malfunction.
– To deactivate progressive scan function manually;
1) Turn off your TV progressive scan mode (or set to
1) Turn off your TV progressive scan mode (or set to
interlaced mode)
2) Press OPEN/CLOSE to open the DVD player disc
tray.
3) Press the numeric keypad ‘1’.
– Check the audio connections, the red and white
jacks are connected correctly.
– Set the Digital output correctly, based on the
equipment you connected to the DVD player.