Справочник Пользователя для Philips BDH4222V/00
User Manual BDH4222V/4223V
32
Changing the Input Source for Main Picture
1
Press the INPUT key or any of the DIRECT INPUT KEYS to change.
Notes:
●
PIP mode can only be turned on if the monitor’s input is set to: AV1,
AV2 (S-Video), Component 1 and 2. If the monitor’s main input is set
to RGB or DVI, the PIP and POP will not function.
AV2 (S-Video), Component 1 and 2. If the monitor’s main input is set
to RGB or DVI, the PIP and POP will not function.
●
If the monitor’s input is set to Component 1 or Component 2, the
PIP will only turn on if the input signal source is compatible with
15KHz signals such as 480i and Y/C
PIP will only turn on if the input signal source is compatible with
15KHz signals such as 480i and Y/C
B
/C
R
signals.
●
When changing input source for sub-pictures to Component 1 and
Component 2, only 15KHz compatible signals such as 480i and Y/C
Component 2, only 15KHz compatible signals such as 480i and Y/C
B
/
C
R
will result in a video picture display. If another signal other than
15KHz is detected, the sub-picture may display distorted video
signals.
signals.
●
Once PIP is turned off, the next time you return on PIP mode, the
position of the sub-window will start at default position.
position of the sub-window will start at default position.
Accessing PIP and POP Modes Modes using OSD
To access these modes using OSD:
1
Press the MENU +/- keys on the remote or on the front control
panel of the monitor.
panel of the monitor.
2
Use the ADJ +/- keys to switch to "PIP/POP" Menu.
3
Make sure that the "Picture" OSD menu below is displayed.
4
Use the MENU +/- keys to move up and down to choose the sub-
category you wish to change.
category you wish to change.
5
Use the ADJ +/- keys to actually change the setting.
PIP options:
■
PIP On/Off
■
Input Source Selection
■
PIP Window Position
Choose between FIXED or VARIABLE windows position:
●
If set to FIXED, the PIP window can be set in any of the four
corners of the screen. Use H-LOCATION and V-LOCATION to
set the position of the window.
corners of the screen. Use H-LOCATION and V-LOCATION to
set the position of the window.
●
If set to VARIABLE, the PIP window can be variably set to
anywhere on the screen using H-LOCATION and
V-LOCATION.
anywhere on the screen using H-LOCATION and
V-LOCATION.
■
PIP Window SWAP
By default, the OSD will always display DISABLE. To swap the main
and sub windows, use the ADJ +/- key to swith to ENABLE. Once
the swap is complete, the OSD will return to display DISABLE.
By default, the OSD will always display DISABLE. To swap the main
and sub windows, use the ADJ +/- key to swith to ENABLE. Once
the swap is complete, the OSD will return to display DISABLE.