Справочник Пользователя для Philips 7FF3FPW/00

Servisní a záruční podmínky

Ms. Delmer F. Teglas

Philips Electronics North America

E-mail: butch.teglas@philips.com

Tel: +1 865 521 4322

This product comply with RoHs and Philips

BSD (AR17-G04-5010-010) requirements

Philips Consumer Electronics declare under

our responsibility that the product is in

conformity with the following standards

•  EN60950:2000 (Safety requirement of

 Information Technology Equipment)

•  EN55022:1998 (Radio Disturbance

 requirement of Information Technology

 Equipment)

•  EN55024:1998 (Immunity requirement of

 Information Technology Equipment)

•  EN61000-3-2:2000 (Limits for Harmonic

 Current Emission)

•  EN61000-3-3:1995 (Limitation of Voltage

 Fluctuation and Flicker)

 following provisions of directives  

 applicable

•  73/23/EEC (Low Voltage Directive)

•  89/336/EEC (EMC Directive)

•  93/68/EEC (Amendment of EMC and Low

 Voltage Directive)

 and is produced by a manufacturing

 organization on ISO9000 level.

 Note:

This equipment has been tested and found

to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide

reasonable protection against harmful

interference in a residential installation.

This equipment generates, uses and can

radiate radio frequency energy and, if not

installed and used in accordance with the

instructions, may cause harmful interference

to radio communications. However, there

is no guarantee that interference will not

occur in a particular installation. If this

equipment does cause harmful interference

to radio or television reception, which can

be determined by turning the equipment

off and on, the user is encouraged to try to

correct the interference by one or more of

the following measures:

•  Reorient or relocate the receiving

 antenna.

•  Increase the separation between the

 equipment and receiver.

•  Connect the equipment into an outlet on a

 circuit different from that to which the

 receiver is connected.

•  Consult the dealer or an experienced

 radio/DPF technician for help.

 Caution:

Changes or modifications not expressly

approved by the party responsible for

compliance could void the user’s authority to

operate the equipment.

Connections to this device must be made

with shielded cables with metallic RFI/EMI

connector hoods to maintain compliance

with FCC Rules and Regulations.

To prevent damage which may result in

fire or shock hazard, do not expose this

appliance to rain or excessive moisture.

ČESKY